Maytag MWF4200AWS Technical Information download pdf (Page 59)

5-9

Step 3 – Submerse the end of the pressure gauge

into the solution and maintain it in an upright

position for 5 minutes. Do not submerse entire

gauge into the sanitizer as it may damage the

internal components.

Step 4 – Reassemble the pressure gauge adaptor

with Teflon tape and tighten using the drinking

water tool kit wrenches.

5.4 Installation

The MAYTAG Whole Home Water Filtration System must be filled with water at all times after

installation. Failure to do so may cause the System to dry and become damaged, which may lead to

personal injury, and/or physical damage.

Ball valves (not supplied), must be used for the System to function properly.

Note: Some parts mentioned in the following sections are not supplied with the System. Be

familiar with the procedures, parts and requirements prior to an installation.

5.4.1 Pre-Installation Inspection

Prior to beginning the installation, look for the following items;

• Location for the MAYTAG Whole Home Water Filtration System

o Space near Point of Entry

o Level area

o Indoors with ambient temp between 40-90 F or 4 – 32 deg C.

o Footprint, minimum 18”x24” or 46cm x 61cm

o Clearance height (floor to ceiling, min 74” or 188cm)

o Drillable Floor

§ If there is floor heating, will require 2’x2’ patio stone and additional height.

§ If there is a wooden floor, will require ¼”screws and washers

• Electrical outlet, 120VAC within 10’

• Existing water equipment (water softeners, filters downstream and UV upstream)

• Household water pressure >35 psi (ideal 50-70 psi):

• Drain accessible within 20’ and up to 72” high for MWF 4100 AWS / MWF 4200 AWS and must

be gravity fed for MWF 4300 AWS.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 134 135

No comments

Maytag MWF4200AWS Technical Information Page 59