5-23
Step 3 - Secure the System electrical wires neatly
using tie-wraps
5.4.7.3 Plug in and set Base Controller
Step 1 – Attach solenoid valve to the solenoid
plug, paying close attention to the orientation of
the prongs. Ensure that the gasket is installed
between the plug and adapter valve.
Step 2 – Secure the solenoid plug to the solenoid
by tightening using a standard screwdriver.
Ensure that a flat gasket is installed between the plug adaptor and valve. Failure to install will increase
the risk of shock if electrical connection comes into contact with water. Personal injury and/or property
damage may result.
Step 3 – Install two AA batteries supplied with
the controller. Replace battery cover.
Step 4 – Connect power supply cord to the wall
outlet.
Comments to this Manuals