Maytag MWF4200AWS Technical Information download pdf (Page 57)

5-7

5.3 Installation Requirements

The Drinking Water Tool Kit should be maintained in premium condition so that the risk of cross-

contamination is minimized. Bacteria, parasites, and viruses can live for long periods of time. As a

result, dangerous organisms can be carried from one installation or maintenance site to another and may

potentially cause serious personal injury, sickness and/or death. Proper tool care and MAYTAG

disinfection procedures will minimize these risks. The procedures are described below.

Ball valves are recommended for use on all bypass, inlet and outlet plumbing from the System. Gate

valves have a tendency to leak and may cause personal injury, sickness and/or death.

The following list of tools and supplies are required (not provided) for installation:

Required hand tools and supplies

Hand Tools

fine slot driver: 1/8" x 4" tube cutter- to 1 1/4"

Phillips drivers: #0, 1 masonry drill bit: 3/8"

slip joint pliers: 12" pencil

needle nose pliers torch head (self lighting)

pipe wrench: 12" hammer drill

adjustable wrench: 12" strap wrench- 36"

torpedo level 120VAC (or manual) air compressor

tire pressure gauge (0-50psi) Integrity tester

tape measure: 3/4"x16' press. gauge with septum needles (0-100psi) (2)

open end wrench set: 3/8", 7/16", 1/2", 9/16", 5/8" (or

6” adjustable wrench)

Snips

Robertson driver: #1 (green), #2 (red), #3 (black) Cap Wrench

Nut drivers: 5/16”, ¼”, 3/8”(optional)

Supplies

teflon tape pipe dope(approved for potable)

flux 3/4" brass union: soc x soc or flexhoses

solder(lead free) 3/4" 90's Cu (soc)

flux brush 3/4" connectors Cu(soc)

emery cloth 3/4" T's Cu (soc)

propane or MPS gas 1/2" ABS hose (70psi test)

silicon grease- Dow 111 NSF approved 1/2" PVC hose barb 90's

tie wraps: 10-14" 1"x3/4" PVC bushing (MNPTxFNPT)

suspension strap misc 1/2" fittings

3/4" ball valves (3) 1/2-3/4" hose clamps

chlorine bleach, 5-6% or 12% chlorine 3/4" brass check valve(FNPT)

Spare parts

8" o-rings base controller(complete)

aa batteries adv controller(complete)

air vent external prefiter dual density cartridge

1/4" FNPT test needle 3/4" brass T's FNPT

1/4" MNPTxhose John Guest valve 1/4" septum sample port

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 134 135

Comments to this Manuals

No comments

Maytag MWF4200AWS Technical Information Page 57

Comments to this Manuals

Related products and manuals for Water dispensers Maytag MWF4200AWS