Maytag MWF4200AWS Technical Information download pdf (Page 111)

6-20

Step 7 – Pull the internal prefilter straight up and

out of the System and drip dry to remove excess

water. If not reusing, place into garbage bag and

dispose. If reusing or cleaning, place on a clean

surface.

Step 8 – Inspect the prefilter spigot, located inside

the internal prefilter housing, and remove any

debris if necessary.

Step 9 – Partially fill the System (with the System

Cap off) by opening the inlet valve partially to

allow water to fill the System. Continue to fill

until the prefilter housing is between ¼ and ½ full.

This will remove any remaining air pressure in the

System.

Step 10 – Pour 250mL of 12% unscented chlorine

bleach or 500mL of 5% or 6% unscented chlorine

bleach into the prefilter housing as illustrated. Be

careful not to allow its contents to come in contact

with any skin or clothing.

NOTE: Filling too quickly, may lead to trapped air that may cause bubbling and splashing.

If this does occur, close the Inlet valve slightly to slow the flowrate into the System. After

filling to the appropriate level, close the Inlet valve.

NOTE: Chlorine bleach must be a new bottle (within 3 months). The effective

concentration is reduced in an open bottle over time.

View looking

into top of the

System.

Spigot

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 134 135

No comments

Maytag MWF4200AWS Technical Information Page 111