Maytag 1800 W - 2005 Specifications download pdf (Page 11)

Troubleshooting Procedures

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless

testing requires power.

Problem Possible Cause Correction

Self-clean cycle not

working

Programming error .....................................

Door lock ....................................................

• Turn off circuit breaker for five minutes

and try oven again.

• Verify door lock energizes & engages.

Frequent cycling of

surface element or

warming zone

Normal........................................................

• Element cycles to maintain proper heat

and to prevent damage to smoothtop.

Fault Code Chart

Fault Code Description Component to Troubleshoot/Replace

F0-0 No Fault......................................................

• None.

F1-1 Oven temperature above 650° F

(343° C) in bake mode ...............................

• Ohm sensor and harness (see "Oven

Sensor" chart). If OK, change control.

F1-3 Oven temperature above 950° F

(510° C) during a clean cycle.....................

• Ohm sensor and harness (see "Oven

Sensor" chart). If OK, change control.

F1-5 Cancel pad not responding ........................

• Ensure ribbon cable is securely

connected, inspect ribbon cable and

connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-7 Membrane disconnected............................

• Ensure ribbon cable is securely

connected, inspect ribbon cable and

connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-8 Shorted key (pad) in membrane switch .....

• Ensure ribbon cable is securely

connected, inspect ribbon cable and

connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-9 Internal control communication errors........

• Replace control.

F1-A Lock/unlock switch state not advancing

to control.....................................................

• Check connections, harness, and

motor. If OK, replace control.

F1-C Oven door switch state not advancing to

control.........................................................

• Check connections, harness, and

motor. If OK, replace control.

F1-E Control not calibrated .................................

• Replace control.

F1-F Jumper not removed from printed circuit

board (PCB) ...............................................

• Remove jumper from PCB.

F1-H EEPROM error ...........................................

• Replace control.

F1-N Internal voltage for slave micro incorrect ...

• Replace control.

F3-1 Open or shorted sensor .............................

• Ohm sensor and harness.

F8 Shorted meat probe ...................................

• Check probe jack and harness probe

jack harness. If OK, check meat probe

(see "Meat Probe" chart).

F9-1 Oven door will not lock ...............................

• Check wire connections. If OK,

replace motorized door lock.

F9-2 Oven door will not unlock ...........................

• Check wire connections. If OK,

replace motorized door lock.

F9-3 Oven door status is both locked and

unlocked.....................................................

• Check wire connections. If OK,

replace motorized door lock.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 54 55

Comments to this Manuals

No comments

Maytag 1800 W - 2005 Specifications Page 11

Comments to this Manuals

Related products and manuals for Microwaves Maytag 1800 W - 2005