Maytag 1800 W - 2005 Specifications download pdf (Page 28)

Installation Instructions (Models JES8750AA*, JES8850A**)

MOBILE HOMES

The installation of a range designed for mobile home

installation must conform with the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part

3280 (formerly the Federal Standard for Mobile Home

Construction and Safety, Title 24 HUD, Part 280) or,

when such standard is not applicable, the Standard for

Manufactured Home Installations 1982 (Manufactured

Home Sites, Communities and Set-Ups), ANSI

A225.1-latest edition, or with local codes.

LOCATING THE RANGE

Place range in a well lit area. Do not set range over holes

in the floor or other locations where it may be subject to

strong drafts. Any opening in the wall behind the range

and in the floor under the range should be sealed. Make

sure the flow of cooling/ventilation air is not obstructed

below the range.

NOTE:

A range should NOT be installed over kitchen

carpeting.

ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS

WARNING :

A risk of range tip-over exists if the appliance

is not installed in accordance with the provided installation

instructions. The proper use of this device minimizes the

risk of TIP-OVER. In using this device the consumer must

still observe the safety precautions as stated in the USE

and CARE MANUAL and avoid using the oven doors as a

step stool.

Installation instructions are provided for wood and cement

in either floor or wall. Any other type of construction may

require special installation techniques as deemed

necessary to provide adequate fastening of the ANTI-TIP

bracket to the floor or wall. The bracket may be installed

to engage the LEFT or RIGHT rear leveling foot.

NOTE:

The bracket provided is designed for use with

flush mount and non-flush mount outlet receptacles.

Install the bracket with the orientation hole in the longer

leg against the wall as shown in figure 5.

STEP 1 - Locating The Anti-tip Bracket (See Figure 5)

A. Determine where either the right or left “EDGE” of the

range will be located and mark the floor or wall.

B. Place the BRACKET 15/16 (24mm) from the marked

“EDGE” toward center of opening and against the

back wall as shown in figure 5, with orientation hole

against wall.

C. Use the bracket as a template and mark the required

holes, as shown in figure 5, for the type of

construction you will be using.

D. Anti-tip bracket may be secured to either floor or wall.

See Step 2 on page 6 for bracket installation options.

FIGURE 5

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 54 55

Comments to this Manuals

No comments

Maytag 1800 W - 2005 Specifications Page 28

Comments to this Manuals

Related products and manuals for Microwaves Maytag 1800 W - 2005