Maytag 1800 W - 2005 Specifications download pdf (Page 39)

Installation Instructions (Models JES9750A**, JES9800A**, JES9860A**)

NOTE:

The mounting br ackets shown in figure

16 are as assembled at the factory for floor or

rear wall venting.

a. Right side venting (figure 17).

1. Remove nuts from studs 1, 2 and 3 on the

motor side.

2. Remove bracket and reattach with studs 1 and

2 inserted in holes A and C and replace 3 nuts.

3. Remove nuts from studs 5, 6 and 7 on air inlet

side.

4. Remove bracket and reattach with studs 5 and

6 inserted in holes D and B and replace 3 nuts.

b. Left side venting (figure 17).

1. Remove nuts from studs 1, 2, 3 and 4 on motor

side.

2. Remove bracket.

3. Rotate motor and cover assembly 180 degrees.

4. Reattach bracket with studs 4 and 1 inserted in

holes A and C and replace all 4 nuts.

5. Remove nuts from studs 5, 6, 7 and 8 on inlet

side.

6. Remove bracket and reattach with studs 8 and

5 inserted in holes D and B and replace all 4

nuts.

5. Attach the blower housing to the floor with the outlet

towards the direction of the venting and the inlet

towards the front of the cabinets. In addition, for left

side venting, a spacer of approximately 1-1/2 thick x

9 long (3.81 cm x 22.86 cm) is required under the

mounting bracket flanges of the blower assembly (see

figure 17).

6. Remove the inside wire and outside string from the

first 1-1/2 (3.81 cm) of one end of the 5 (12.7 cm)

flex duct (P/N 702935). Stretch this end of the flex

duct over the end of the 5 x 3-1/4 x 10 (12.7 cm x

25.4 cm) transition and secure with hose clamp (P/N

702331).

7. When the range is placed in position, feed the open

end of the 5 (12.7 cm) flex duct through the hole in

the cabinet side wall and attach to the outlet of the

blower housing with hose clamp (P/N 702331). The

transition should then be attached to the 3-1/4 x 10

(12.7 cm x 25.4 cm) ducting in the cabinet toe space

through the cabinet floor cutout.

Figure 15

Right Cabinet (Top View)

Figure 16

Blower Assembly

Figure 17

View from Air Inlet Side of Blower

3. Make cutout in the cabinet floor of either the ri

ht or

left side cabinet as shown in figures 14 or 15.

4. Relocate the mounting brackets on the blower

housing as shown in figure 17.

Figure 14

Left Cabinet (T op View)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 54 55

Comments to this Manuals

No comments

Maytag 1800 W - 2005 Specifications Page 39

Comments to this Manuals

Related products and manuals for Microwaves Maytag 1800 W - 2005