Maytag 1800 W - 2005 Specifications download pdf (Page 37)

Installation Instructions (Models JES9750A**, JES9800A**, JES9860A**)

3-WIRE SERVICE CORD OR CONDUIT

INSTALLATION

1. Insure that the copper ground strap

IS CONNECTED

between the middle post of the main terminal

connection block and the range chassis.

2. The middle wire of the service cord or ground lead of

3-wire conduit

MUST

connect to the neutral (middle)

post of the main terminal block. The other two wires of

the service cord or conduit connect to the outside

posts of the main terminal connection block. Polarity is

unimportant.

3. A appropriate strain relief for service cord or conduit

must be attached to the conduit plate.

FIGURE 8

ACCEPTABLE 3-WIRE PLUG INSTALLATION

4-WIRE SERVICE CORD OR CONDUI

INSTALLATION

(MOBILE HOMES OR AS REQUIRED BY CODES)

1. The copper ground strap connected between the

neutral (middle) post of the main terminal block and the

chassis

MUST

be cut off as shown in figure 9. Save the

green ground screw to attach the ground from the 4

wire cord. Only a 4 wire cord or conduit should be

used.

2. The ground wire from the service cord or conduit must

connect to the range chassis using the green ground

screw.

3. The white wire of the service cord or conduit must

connect to the neutral (middle) post of the main

terminal block. The other two wires of the service cord

or conduit connect to the red and black posts of the

main terminal block, respectively.

4. An appropriate strain relief for service cord or conduit

must be attached to the conduit plate.

CONVERSION FROM 3-WIRE TO 4-WIRE

SERVICE

(Model With 3-Wire Service Cord Attached)

Disconnect range from power. Remove the access cover

on back of range and remove the 3-wire service cord from

the main terminal block. Follow instructions as outlined in

figure 9 to connect the 4-wire service cord.

NOTE:

Cord replacement -

ONLY

a power supply cord

rated at 240 volts minimum, 40 amperes or 50 amperes

power supply cord that is marked for use with nominal

1 3/8 (34.93 mm) diameter connection opening, with

closed loop terminals and marked for use with ranges

shall be used.

FIGURE 9

ACCEPTABLE 4- WIRE PLUG INSTALLATION

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 54 55

Comments to this Manuals

No comments

Maytag 1800 W - 2005 Specifications Page 37

Comments to this Manuals

Related products and manuals for Microwaves Maytag 1800 W - 2005