Maytag 1800 W - 2005 Specifications download pdf (Page 19)

Testing Procedures

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless

testing requires power.

Description of Fault Codes

Each Fault Code consists of an "F" followed by a number, dash and a number or letter. The following table

describes each Fault Code and the component to troubleshoot.

To view the most recent fault code:

1. Press and hold the

Cancel

and

Broil

pads for 3 seconds at power-up, or within 5 minutes of power-up.

2. Once the control has entered the "Quick Test" mode, release both pads.

3. Press the

Cook Time

pad to view the most recent fault (displayed in the control display window).

Fault

Code

Description Component to Troubleshoot/Replace

F0-0 No Fault. None.

F1-1

Oven temperature above 650° F (343° C) in bake mode.

Ohm sensor and harness (see "Oven Sensor" chart, pg

12). If OK, change control.

F1-3

Oven temperature above 950° F (510° C) during a clean

cycle.

Ohm sensor and harness (see "Oven Sensor" chart, pg

12). If OK, change control.

F1-5 Cancel pad not responding.

Ensure ribbon cable is securely connected, inspect

ribbon cable and connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-7 Membrane disconnected.

Ensure ribbon cable is securely connected, inspect

ribbon cable and connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-8 Shorted key (pad) in membrane switch.

Ensure ribbon cable is securely connected, inspect

ribbon cable and connector (shorts, breakage, corrosion,

etc.). If OK, replace control.

F1-9 Internal control communication errors. Replace control.

F1-A Lock/unlock switch state not advancing to control.

Check connections, harness, and motor. If OK, replace

control.

F1-C Oven door switch state not advancing to control.

Check connections, harness, and motor. If OK, replace

control.

F1-E Control not calibrated. Replace control.

F1-F Jumper not removed from printed circuit board (PCB). Remove jumper from PCB.

F1-H EEPROM error. Replace control.

F1-N Internal voltage for slave micro incorrect. Replace control.

F3-1 Open or shorted sensor. Ohm sensor and harness.

F8 Shorted meat probe.

Check probe jack and harness probe jack harness. If

OK, check meat probe (see "Meat Probe" chart, pg 12).

F9-1 Oven door will not lock.

Check wire connections. If OK, replace motorized door

lock.

F9-2 Oven door will not unlock.

Check wire connections. If OK, replace motorized door

lock.

F9-3 Oven door status is both locked and unlocked.

Check wire connections. If OK, replace motorized door

lock.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 54 55

Comments to this Manuals

No comments

Maytag 1800 W - 2005 Specifications Page 19

Comments to this Manuals

Related products and manuals for Microwaves Maytag 1800 W - 2005