Maytag 111405-1 Service Manual download pdf (Page 75)

Blocking the Unit:

 If there is a solid soffit above the unit and the clearance is 1"

 or less you will not need to block the unit. For installations with

 clearances of more than 1", you must use the anti-tipping 2x4

 and brackets provided (Fig. 6).

More than

an 1"

Soffit

Fig.

More than 1" clearance:

 Use the anti-tipping kit provided with the shipping crate. Locate and

 mark the 2 wall studs behind the unit. Mark where the "L" brackets

 and 2x4 will be located and drill 2 pilot holes 1/8". Locate the proper

 height to clear the unit. The space between the top of the unit and

 bottom of the wood block must not exceed 1/4". Secure the "L"

 brackets, using the provided screws, into the wall studs (À). Make

 sure the screws will extend 7/8" into the wall studs. Align the pilot

 holes with the "L" brackets and secure the 2x4 with the screws

 provided(Á,Â).

Wall Studs

Installing Backer Panels:

 Remove the door handle or trim piece on overlay models. A magnetic backed molding hides the handle or overlay trim screws. Use the

 adhesive side of the packaging tape on the magnetic backed molding to pull it away from door (Fig. 8a). Remove the screws with a

 phillips screwdriver (Fig. 8b). Slide the backer panel into position. The backer panel needs to be under the trim. Install the handle.

 Replace the molding in the channel, and reset the magnetic backed molding. To install the backer panel on the grille remove the screws

 on the top and bottom of the upper cover (Fig 8c). DO NOT REMOVE the foam. Slide the backer panel into place and replace screws

 (Fig 8d). If the thickness of the backer panel is less than a 1/4", back it up with a sheet of shim material to obtain a 1/4" thickness.

 Cardboard is recommended for Stainless Steel application. For panel size refer to Fig. 10.

Fig.

Grille Panel

Fig.

CAUTION:

Do not drive screws or sharp objects into the doors.

Do not pinch door seal when reinstalling handle.

Phillips Screwdriver

Use Tape

to Pull Magnetic

Molding Away

from Door

Approximate Position

For Screws

CAUTION:

When attaching a raised wood

panel of 1/2" or thicker secure the

raised panel to the back of the grille

cover frame. Use 4 #8 or similar screws.

See illustration for approximate locations.

Fig.

1 2 ... 70 71 72 73 74 75 76 77 78

Comments to this Manuals

No comments

Maytag 111405-1 Service Manual Page 75

Comments to this Manuals

Related products and manuals for Fridges Maytag 111405-1