Maytag 111405-1 Service Manual download pdf (Page 29)

29 16021730 Rev. 0

5. Remove the wiring harness quick disconnect

connector.

6. Remove the two fan backet assembly mounting

screws.

7. Remove the fan blade by pulling it off the shaft.

Mounting

Screws

Figure 1

Mounting

Screw

Mounting

Screw

Figure 2

Figure 3

8. Remove the screws that secure the rear bracket

to the front bracket. Remove the motor from the

rear mounting bracket.

9. Install the new motor to the rear mounting

bracket. Mount the rear bracket to the front

mounting bracket.

10.Install the fan blade on the replacement motor.

The fan blade is provided with a stop on the face

of the hub. It is properly installed when the blade

is positioned so the stop rests against the end of

the shaft.

11. Replace the fan motor assembly in reverse order

of removal.

Defrost Heaters

Two radiant defrost heaters are used to remove the

accumulated frost from the freezer evaporator during

a defrost cycle. These heaters are wired in series,

thus comprising the defrost heater system.

REPLACING THE DEFROST HEATERS

1. Shut the main power switch off.

2. Perform steps 6 through 17 of Evaporator

Replacement.

3. Using long nose pliers remove the two front and

back wire retainer clips. (One on the right side

and one on the left. Carefully lower the radiant

defrost heaters. (See figure 1).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

No comments

Maytag 111405-1 Service Manual Page 29