Maytag 111405-1 Service Manual download pdf (Page 73)

Preparing the Space:

 Make sure the opening where the unit will be installed, is

 properly prepared for "Cut Out" dimension. Check placement

 for electrical outlet and water line. (Fig. 1)

NOTE:

 For the door to open properly, it must be able to open at

 least 90 degrees. For installation in a corner, a 2" filler strip is

 required to ensure the 90 degree opening. The floor under the

 refrigerator is to be level with the surrounding floor. To protect

 the floor when moving the refrigerator, place cardboard, or

 preferably a carpet remnant (backing up) on the floor.

  Electrical Connection:

 Refer to User Guide for voltage requirements. There should

 be a separate, grounded circuit serving this appliance only.

 Do not use an extension cord. Do not use any device that will

 alter the electrical performance of this appliance. For the

 placement of the electrical outlet refer to Fig. 1.

 *Do not use a ground fault circuit interupter.

Plumbing Connection:

 Rough in the water line for the location (Fig. 1). Connect a

 1/4" copper line to the house supply. Use a shut off valve

 between the refrigerator and supply. The shut off should be

 a drilled saddle valve. Do not use a self-tapping valve. The

 icemaker operates on 30 to 120 PSI. Route the water line

 within a 1/2" of the wall and no higher than 3" from the floor.

 Allow at least 3' of excess copper tubing outside the wall or

 floor for easy connection to the water valve. * Prior to

 connection assure that the water supply and the copper

 tubes have been flushed until the water runs clear.



Reverse Osmosis: Remove the water inlet connector from

 the 'Yellow' valve and attach to the 'Blue' valve. Assure that

 the water filter bypass plug is in place (See Fig. 3).

 Disconnect wires from Yellow Valve.

Installation Instructions

Fig.

(48"/121.9) 47 1/2"/120.7

(42"/106.7) 41 1/2"/105.4

24"

60.96

3 1/2"

8.89

3"/7.62

15.24

(48"/121.9

42"/106.7)

83 3/4"

212.7

Side View

Front View

75 1/2"

191.8

5.08

10.16

17.78

RearFront

Electrical supply needs

to be located in this area.

Water supply needs to be

located in the shaded area.

WARNING:

3"/7.62

Installation Checklist:

 INSTALLER

  Doors

   Handles are solidly attached to doors.

   Doors seal completely to refrigerator cabinet.

   Assure correct door handle alignment. Frame models.

   Assure door seals are not pinched.

   Do not drive screws / sharp objects into the doors.

 Leveling

  L Brackets are secure to 2x4 wood block.

  Stabilizing legs are against floor. Cabinet is secure.

  Toe kickplate is properly attached to refrigerator

    and aligned with floor.

 Icemaker

  Water supply to refrigerator is turned on and lines flushed.

   Water leaks are not present at connection between household

    water supply and refrigerator.

   Icemaker arm is down for ice production.

   PuriClean

Ice and Water Filtration System is installed correctly,

    if applicable.

   Purge water from the fountain on dispenser models.

Tool Requirements:

 Tape measure

 Level

 Stud finder

 Drill with various bits

 Socket set

 Utility knife

 Magnetic extended screwdriver

 Phillips screwdriver

 Torx Bit

 Cardboard, carpet remnant or other

 protective material for flooring

 Steel Hanger Strap

1 2 ... 68 69 70 71 72 73 74 75 76 77 78

Comments to this Manuals

No comments

Maytag 111405-1 Service Manual Page 73

Comments to this Manuals

Related products and manuals for Fridges Maytag 111405-1