Maytag 111405-1 Service Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 78
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
25 16021730 Rev. 0
Figure 3
5. Disconnect the fan motor wire lead connector.
(See figure 4)
Wire Lead
Connector
Figure 4
6. Evacuate the sealed system.
7. Use steel wool or fine emery paper to clean and
then cut the inlet and the outlet tube of the old
condenser.
8. Clean both the inlet and outlet end of the new
condenser.
9. Remove the condenser assembly from the
compressor mounting pan and place it on a
workable surface.
10.Remove the shroud/condenser screws which
secure the fan motor shroud to the condenser.
11. Transfer all clips to the replacement condenser.
Install the mounting screws.
12.Set the replacement condenser on the
compressor mounting pan and install both front
and rear condenser mounting screws.
13.Clean then connect the discharge line to the
inner tubing. Clean and connect the Yoder loop
to the outer tubing of the condenser.
14.Solder all joints. Silver solder and proper flux
should be used on copper to steel or steel to
steel joints. Excess flux should be wiped off all
tubing.
15.Remove and replace the old drier. Do not allow
more than 1/2" of the cap tube to penetrate
the drier.
16.Install the new drier using silver solder with the
proper flux.
17.Visually check the joints for leaks.
18.Connect the fan motor wire connector.
19.Evacuate and recharge the system.
EVAPORATOR REPLACEMENT
1. Remove the Machine compartment access door.
2. Turn the main power switch in the machine
compartment to the off position.
3. Remove the high side slide rail mounting screw.
4. Slide the highside assembly forward into the
service position.
5. Evacuate the sealed system.
High Side
Process Line
to the Drier
Low Side
Process Line
6. Open the freezer door and push back on the light
shield retaining tabs then lower the shield. (See
figure 1)
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 77 78

Comments to this Manuals

No comments