Maytag W10385090A Use and Care Guide download pdf (Page 56)

First try the solutions suggested here or visit our website at www.maytag.com/help

for assistance and to possibly avoid a service call.

Clothes are not drying The load is too large and heavy Separate the load to tumble freely.

satisfactorily or drying to dry quickly.

times are too long

Dryer sheets are blocking the grille. The air outlet grille is just inside the door, beMnd the lint screen.

Check that it is not blocked by a dryer sheet.

Use only one dryer sheet, and use it only once.

The dryer is located in a room with Proper operation of dryer cycles requires temperatures above

temperature below 45°F (7°C). 45°F (7°C).

The dryer is located in a closet. Closet doors must have ventilation openings at the top

and bottom of the door. The front of the dryer requires

a minimum of 1" (25 mm) of airspace, and, for most

installations, the rear of the dryer requires 5" (127 mm).

See "hstallation hstructions".

Cycle time is too short The load may not be contacting the Level the dryer. See "hstallation hstructions". All four dryer

sensor strips on Sensor Cycles. feet should be in firm contact with the floor.

Clothes are coming out of the

Refresh cycle with damp or wet

spots.

The sensor cycle is ending early.

Under certain environmental or installation conditions you

may experience underdrying. Select the Auto Refresh cycle

(20 min. default time), wMch can be customized by selecting

High temperature. The cycle time will automatically be

calculated based on the size of your load.

Change the dryness level setting on Sensor Cycles. Increasing

or decreasing the dryness level will change the amount of

drying time in a cycle. If loads are consistently ending too

early, see also "Changing the Sensor Cycle settings to increase

drying time".

Lint on load Lint screen is clogged with lint. Clean lint screen before each load.

Stains on load Improper use of dryer sheets. Add dryer sheets at the beginning of the cycle. Dryer sheets

added to a partially dried load can stain your garments.

Do not use dryer sheets with steam cycles.

Stains on drum Loose dyes in clothes. Drum stains are caused by dyes in clothing (usually blue

jeans). These will not transfer to other clothing.

Loads are wrinkled

The load was not removed from

dryer at the end of the cycle.

The dryer was overloaded.

For steam cycles, the water is not

properly connected with the dryer.

Loads are wrinkled

(Steam models only)

On steam models, select Auto or Custom Refresh cycle to

tumble the load with water and heat. On non-steam models,

select Freshen Up. These cycle are best for smoothing out

wrinkles and reducing odors from loads consisting of wrinkle-

free cotton, cotton-polyester blends, common knits, and

synthetic garments.

NOTE: Refer to garment care label instructions. Dry clean only

garments are not recommended.

Dry smaller loads that can tumble freely. When using the Auto

Refresh cycle (on steam models), adjust the time based on

the load size. Results may also vary depending on fabric type.

This cycle is best for reducing wrinkles and odors from loads

consisting of wrinkle-free cotton, cotton-polyester blends,

common knits, and synthetics.

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer's water

inlet valve. Check that the water supply is turned on.

1 ... 55 56 57 ... 80

Comments to this Manuals

No comments

Maytag W10385090A Use and Care Guide Page 56

Comments to this Manuals

Related products and manuals for Electric laundry dryers Maytag W10385090A