Maytag MTB1504ARW Operations Instructions download pdf (Page 26)

Disassembly Procedures

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test

procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.

Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Removal

Freezer Door

1. Open both compartment doors. Remove door

buckets, Place components on a padded surface to

avoid damage.

2. Close both doors and tape them shut so they won’t

fall off unexpectedly when hinges are removed.

NOTE: To minimize possibility of personal injury and/or

property damage, make sure unit doors are

taped shut before you undertake the next steps:

3. On top of unit, remove and retain plastic cap from

door hinge.

4. Remove and retain screws from top door hinge.

5. Pull tape off of door and lift door off unit. Set door on

a padded surface to prevent damage to finish.

6. Remove and retain center hinge pin and all plastic

shims. Note number and location of shims as you do

so.

Fresh Food Door

1. Pull tape off fresh food door and lift door off unit. Set

door on a padded surface to prevent damage to

finish.

2. If clearance requirements so dictate, remove center

and lower door hinges:

a. Remove screws from center hinge bracket.

Remove and retain bracket, screws, and all shims.

b. On some models the toe grill will need to be

removed. To do this either unscrew the screws

that hold it in place or if the grill is held in by clips

pull the grille from each end to release it from the

unit.The grille is fragile: keep both parts safe from

harm.

c. Remove bottom hinge pin and all shims from

bottom hinge bracket. Note number and location

of shims. Retain all parts.

d. Loosen mounting screws from bottom hinge

bracket. Remove and retain bracket and bolts.

Refrigerator Compartment

Defrost Timer

Cold Control

Light Switch

Light Socket

Light Bulb Cover (some models)

1. To remove the light cover squeeze and unsnap the

light cover.

2. Remove light bulb.

Light Bulb Socket

1. Remove the light cover as descibed above. Retain all

parts.

2. Remove light bulb.

3. Remove two screws holding the Control Housing

Assembly to Fresh Food ceiling.

4. Remove Control Housing Assembly by sliding it down

and forward to release drain tube from back wall.

5. Disconnect wire harness plug from ceiling.

6. On back side of Control Housing Assembly

disconnect wires from light bulb socket.

7. Squeeze tabs on back side of Light Bulb Socket to

release it from housing.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Comments to this Manuals

No comments

Maytag MTB1504ARW Operations Instructions Page 26

Comments to this Manuals

Related products and manuals for Fridges Maytag MTB1504ARW