Maytag MTB1504ARW Operations Instructions download pdf (Page 32)

WARNING

To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before

servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires

removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.

5. Reach into mold anchor-screw access ports with a

Phillips screwdriver and loosen two mold anchor

screws. Then pull support assembly away from

mold.

6. Remove three module anchor screws and pull

module out of support assembly.

7. Pull stripper and ejector off module.

NOTE: During reassembly, align "D" shape of ejector

shaft with "D" shaped socket in module cam.

8. Remove fill cup. Finally (if desired) remove thermal

fuse clip and ice maker bracket.

NOTE: New fill cups are molded with two break-out

slots for a fill tube. This is done so that the same

cup can be used in several applications.

To install a new fill cup:

a. Disassemble ice maker per instructions above.

b. Using ordinary pliers on new fill cup, break out

fill slot required by your application.

c. Mount new fill cup and reassemble ice maker.

Module Anchor screws (3)

Mold Anchor screws (2)

Mold & Heater assembly

Support assembly

Stripper

Fill Cup

Ejector

Ice Maker bracket

Screw

Thermal Fuse clip

Thermostat Retainer clip

Thermostat

Module assembly

(not replaceable,

order new ice maker)

(not replaceable,

order new ice maker)

(not replaceable,

order new ice maker)

(not replaceable,

order new ice maker)

Shut-Off Arm

assembly

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 54 55

Comments to this Manuals

No comments

Maytag MTB1504ARW Operations Instructions Page 32

Comments to this Manuals

Related products and manuals for Fridges Maytag MTB1504ARW