Maytag MB1927PEHB User Manual download pdf (Page 4)

3

INSTALLING YOUR REFRIGERATOR

These instructions were provided to aid

you in the installation of your refrigerator.

The manufacturer cannot be responsible

for improper installation.

Steps to follow…

A qualified engineer must connect

refrigerator in accordance with these

installation instructions. Measure door

opening and depth and width of

refrigerator. Remove handles or doors if

required. Engineer must also do the

following:

1. Follow local water and electrical

company connection regulations.

2. Complete water supply connection

before electrical supply connection.

Service to or replacement of power

cord must be performed by a qualified

servicer.

1. Install on an earthed outlet with a

separate 220-240 volt, 50hz., 10A

circuit.

2. Protect soft flooring with cardboard or

rugs.

3. Provide 5 mm clearance at side of

refrigerator and for models more than

60 cm deep, provide 12.7 mm

clearance at top and back of

refrigerator.

4. 60 cm deep models.

Trim corners of counter top to a 45°

angle if counter top has 25 mm

overhang.

How to remove wooden

base

To avoid personal injury or property

damage, two people must remove

wooden base.

CAUTION

1. Tape doors shut to prevent doors

from opening unexpectedly.

2. Slide appliance cart under side of

refrigerator.

3. Wrap refrigerator with blanket or pad.

Thread strap around refrigerator. Put

foam shipping pads, located in

shipping carton, under strap.

Tighten strap securely.

4. Lower appliance cart to floor with

appliance cart handles on bottom.

5. Remove top two bolts from skid.

6. Return refrigerator and appliance

cart to an upright position. Remove

strap.

7. Slide appliance cart under opposite

side of refrigerator.

8. Repeat steps 3–5.

9. Remove wooden base.

10. Return refrigerator and appliance

cart to an upright position and

remove appliance cart.

IMPORTANT: Do not leave refrigerator

on its side longer than necessary to

remove bolts.

➢ Remove

1

⁄4" hex head screws from

door face with hex head driver.

• If reversing door,

remove door plugs

from opposite side

of door and insert

in screw holes.

➢ Align handle holes

with screw holes on

door face and

secure with 2 door

face screws

previously removed.

➢ Locate handle trim in literature pack

and install over top and bottom of

handle.

• Secure top handle trim

with remaining screw

removed previously.

• Snap bottom trim over

bottom portion of handle.

➢ Align handle holes with screw holes

on door edge and

secure with screws

previously re-

moved.

Installing freezer

handle

If installing handle for the first time, the

freezer handle can be located in the

literature package inside the refrigerator.

➢ Remove Phillips screws from top edge

of freezer door opposite hinge side.

• Retain screws for later replacement.

• If reversing freezer door, remove

door plugs from top edge of door and

insert into screw holes.

Installing fresh food

front-mount handle

If installing handles for the first time, the

fresh food handle can be located within

the fresh food section. The handle trim

will be located in the literature package.

1 2 3 4 5 6 7 8 9 ... 183 184

Comments to this Manuals

No comments