Professional48",36",30" _ JENN-AIRGasRangeModels ,03WEST,OO,T.ST°EE,,,ORT...E_O.,,A,0208@ @ O @ 0=[JRetain this manual for future refer
STEP4: ELECTRICALCONNECTIONSPower Requirements120 VAC, 60 Hz., single phase.PRG3010- 4 Amp. Max.PRG3610- 7 Amp. Max.PRG4810- 13 Amp. Max.(Use 15 Amp.
STEP 6: BACKGUARDINSTALLATIONThe backguard must be installed when there is less thana 12" clearance between combustibles and the back ofthe range
Surface BurnersThe surface burners are not adjustable. Proper operation isachieved when the correct orifices for the gas supply areinstalled at the fa
ii !!ct__mct_0_m0L_L_L__mOzc_Qu
"13Zo01030003<c)LR RF RRLR RF RRA4_:E
SERV[CE BKLi2IN IN 17 GN ON r_I)e l LIO_I_ 6 42OUAL VN I0IN7 u24_ L0IDo(1)r_O-i.--Ou")(D(D-i.--Ozt_n-i.--
-uzo01O_o007O(Do
Zo0_c_C_
q3ZoS03o0CO<oi_ _ ii__¸¸¸ _ i_¸¸ _
30'i GAS RANGE MODEL 36" GAS RANGEMODELMODEL PRG3010 MODEL PRG3610\/ !//MODEL PRG4810
TABLE OF CONTENTSMODEL IDENTIFICATION ... 2WARNING ... 3INTRODUCTION ...
IMPORTANTINSTALLATIONINSTRUCTIONSTested in accordance with ANSI Z21.1-1993 Standard forHousehold Cooking Gas Appliances.These ranges must be installed
STEP 2: CABINETPREPARATION1. The range is a free-standing unit. If the unit is to beplaced adjacent to cabinets, the clearances shown inFigures 2A/B/C
5. Any openings in the wall behind the range and in thefloor under the range must be sealed.6. When there is less than a 12" clearance betweencom
STEP 3: UNPACKING,MOVING ANDPLACING THE RANGECAUTIONPROPER EQUIPMENT AND ADEQUATE MAN-POWER MUST BE USED IN MOVING THERANGE TO AVOID DAMAGE TO THE UNI
To remove the door, open the door and hold it all the wayopen. Close the hinge latches (see Figure 8) and releasethe door. The door can then be remove
ANTI.TIPDEVICE INSTALLATIONNOTE: A risk of range tip over exists if the appliance isnot installed in accordance with the installationinstructions prov
Comments to this Manuals