Maytag T1WG2 Use and Care Guide download pdf (Page 5)

2. Push the top grille straight up, then pull straight out. Lay the

grille on a soft surface.

To Replace Top Grille:

1. Insert top grille hooks (located on the back of the top grille)

onto mounting bolts on the side trim.

2. Pull grille down slightly to lock into place.

Turn Power On or Off:

1. Remove top grille.

2. Press power switch to the On or Off position.

3. Replace top grille.

IMPORTANT: Be sure the power switch is set to the On position

after cleaning refrigerator or changing light bulbs.

Water Supply Requirements

Read all directions before you begin.

IMPORTANT:

■ When your refrigerator was installed, the water connection

from the water source should have been connected to your

refrigerator. If your refrigerator is not connected to a water

source, see “Connect to Water Line” in the Installation

Instructions. If you have any questions about your water

connection, see “Troubleshooting” or call a licensed, qualified

plumber.

■ If you turn the refrigerator on before the water line is

connected, turn the ice maker OFF. See “Ice Maker and

Storage Bin.”

■ All installations must meet local plumbing code requirements.

Water Pressure

A cold water supply with water pressure between 30 and 120 psi

(207 and 827 kPa) is required to operate the water dispenser and

ice maker. If you have questions about your water pressure, see

“Troubleshooting” or call a licensed, qualified plumber.

Reverse Osmosis Water Supply

IMPORTANT: The pressure of the water supply coming out of a

reverse osmosis system going to the water inlet valve of the

refrigerator needs to be between 30 and 120 psi (207 and

827 kPa).

If a reverse osmosis water filtration system is connected to your

cold water supply, the water pressure to the reverse osmosis

system needs to be a minimum of 40 psi (276 kPa).

If the water pressure to the reverse osmosis system is less than

40 psi (276 kPa):

■ Check to see whether the sediment filter in the reverse

osmosis system is blocked. Replace the filter if necessary.

■ Allow the storage tank on the reverse osmosis system to refill

after heavy usage.

■ If your refrigerator has a water filter, it may further reduce the

water pressure when used in conjunction with a reverse

osmosis system. Remove the water filter. See “Water Filtration

System.”

If you have questions about your water pressure, call a licensed,

qualified plumber.

Water System Preparation

Please read before using the water system.

Immediately after installation, follow the steps below to make sure

that the water system is properly cleaned.

1. Turn off the ice maker. Slide the ice maker On/Off control,

located on the left-hand side of the ice bin, to the OFF (down)

position as shown.

NOTE: If your model has a base grille filter system, make sure the

base grille filter is properly installed.

2. Turn on the ice maker. Slide the ice maker On/Off control,

located on the left-hand side of the ice bin, to the ON (up)

position. Please refer to “Ice Maker and Storage Bin” for

further instructions on the operation of your ice maker.

■ Allow 24 hours to produce the first batch of ice.

■ Discard the first three batches of ice produced.

A. Top grille

B. Cabinet side trims

A. Power switch

B BA

A. On/Off control

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or

after the system.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments

Maytag T1WG2 Use and Care Guide Page 5

Comments to this Manuals

Related products and manuals for Fridges Maytag T1WG2