Maytag JUC2450ARS Operations Instructions download pdf (Page 32)

3. Peel back door gasket on the glass door to provide

access to the screw holes used to mount the

wooden frame and the hole for the lock’s extension

section at the top of the door.

4. Place the custom wood panel on a non-abrasive

surface, protected by towels or rugs, to avoid

accidental damage to the door finish.

5. Set the wood frame flush to the front of the door in

the desired location clamp wood frame to the door

if necessary. Check to see that the back of the

lock in the wood frame lines up with the hole in

the door.

6. Insert the wood screws through the back of the

door into the pilot holes in the wood frame and

tighten.

7. Assemble the door lock Phillips screw, lock

extension, lock cam and mount them to the back of

the lock body. Position the door lock cam so that it

projects upward from the top of the door. Tighten

the Phillips screw to secure the lock assembly.

2. Install the supplied lock body into the wood panel.

The lock and key assembly is supplied with your

wine chiller. Secure the lock body by using the

supplied 15 mm lock retaining nut and screwing it

on the lock body’s threaded section. Make sure

that the lock’s key slot is vertical, then tighten the

15 mm nut with a 15 mm deep-well socket.

Magnetic door gasket

Rear of door

Light door

striker plate

Bottom of door

⁄8" Allen head screws for

hinge adjustment (top

and bottom of door).

⁄8" (1.0 cm)

clearance

holes for wood

frame wood

screws

Attached

wood

Frame

Lock body

Key

Lock cam

Phillips

screw

Door

gasket

Glass

door

Wood

panel

Lock

extension

Lock retainer nut

8. Reinstall the door gasket by pressing into door

channel. Make certain the corners are inserted

fully. Insert the key into the lock and make sure

the lock operates properly.

9. Install the door to the wine chiller. Use the

washers (if provided) as shown on page 9.

10. Realigning the door may be necessary. Final door

adjustments can be made using a

⁄8" Allen wrench

to adjust the door hinges (see figure below).

11. Attach the door to the wine chiller by reversing

step number one above.

12. Make certain that the glass door swings freely, the

door gasket seals properly and the interior light

goes on and off as the door opens and closes.

13. Confirm that door lock turns a quarter turn from

vertical to horizontal and that this locks the door

closed.

14. Reconnect the power to the wine chiller. Return

the control knob to its previous setting.

Not required

for 4" toe kick

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Comments to this Manuals

No comments

Maytag JUC2450ARS Operations Instructions Page 32

Comments to this Manuals

Related products and manuals for Wine coolers Maytag JUC2450ARS