Maytag JUC2450ARS Operations Instructions download pdf (Page 27)

Installation, cont.

The wine chiller door can have a left or right hand

swing. Typically the door is installed on the wine

chiller with a right hand swing configuration. To

change to a left hand swing, follow the instructions

listed below.

Materials Needed

•

⁄8" Allen wrench

• Phillips screwdriver with magnetic tip

• Needle-nose pliers

•

⁄16" nut driver

• Small flat-blade screwdriver

Black or white framed model:

• 15 mm deep-well socket and wrench

Custom wood frame or stainless steel frame overlay model:

• 15 mm open-end wrench

1. Note the thermostat control knob setting so you

can reset the thermostat knob to its proper setting

after the door reversal is complete.

2. Turn the thermostat control knob counterclockwise

until the “OFF” setting is at the 12:00 position. The

wine chiller’s refrigeration system will shut off.

3. Using the

⁄8" Allen wrench, remove the screw from

the top hinge of the wine chiller. Be sure to

support the door so that it does not fall. Lift the

door gently up and away from the bottom hinge.

4. Lay the glass door face down on a smooth, non-

abrasive surface protected by towels or rugs to

avoid accidental damage.

5. Using the

⁄16" nut driver, remove the

⁄16" hex head

screws which are holding the top and bottom

hinges. Set screws and hinges aside for later.

6. Using the Phillips screwdriver, remove the Phillips

head hinge pin from the bottom hinge. Set the

hinge, hinge pin and plastic washer aside for later.

For custom wood frame model, skip to step 12.

7. Pull the door gasket out of the door’s back frame,

enough to allow access to the screw holes and the

back of the door lock.

8. Using the Phillips screwdriver, remove the Phillips

screw at the end of the door lock. Set the Phillips

screw lock washer, lock cam and lock/cam

extension pieces aside for later.

9. Stainless steel frame overlay model only: Remove

the ten screws that secure the stainless steel frame

overlay to the glass door. Set the screws aside for

later.

10. Black or white framed model: Use the 15 mm

deep-well sock and wrench.

Stainless steel frame overlay model: use the 15 mm

open-end wrench.

Loosen the retaining nut that secures the lock to

the door frame. If the nut falls back into the door

frame, use the needle-nose pliers to retrieve it and

set the nut aside for later.

11. Gently lift the door end up where the lock is

currently located and let the lock fall out and away

from the door. Set the lock aside for later.

12. Using the Phillips screwdriver, remove the two

screws holding the light striker plate to the back

side of the door.

The following graphic shows the striker plate hole

locations when changing to a left hand door swing.

Remove the light switch striker from the bottom of

the right hand swing door and install the striker

plate in the holes as shown.

• To avoid electrical shock which can cause personal

injury or death, disconnect power to the wine chiller

before reversing the door.

WARNING

Reversing the Glass Door

Lock body

Key

Lock cam

Phillips

screw

Door

gasket

Glass

door

Panel

Lock

extension

Lock retainer nut

⁄

32" (0.4 cm) diameter

two holes, striker plate

Door

gasket

(Back view of glass door)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Comments to this Manuals

No comments

Maytag JUC2450ARS Operations Instructions Page 27

Comments to this Manuals

Related products and manuals for Wine coolers Maytag JUC2450ARS