Maytag LAT9356AAE User's Guide download pdf (Page 4)

STEP 2

• Lay two carton corner posts on the floor.

• Make sure one corner post is placed against

the wooden crate bottom.

• Tip washer forward on its front so it will lay

across both corner posts.

STEP 3

• Remove crate wires and crate base.

STEP 4

• Tip machine upright.

• Slide washer in place near water faucets.

• Prepare to hook up hoses.

STEP 5

Run water through both water faucets into a

bucket to purge the water line particles that

might clog the hoses. While running water

through the faucets, determine which faucet is

HOT water and place an identifying mark on it.

Traditionally the HOT water faucet is on the

STEP 1

• Remove all items from inside of wash tub.

• Replace tub block and tape lid shut.

• Remember! After installation is completed,

the tub block needs to be removed.

STEP 6

Insert one screen and then one washer into

the faucet ends of the inlet hoses. The

screens should be pointing out to fit properly.

STEP 7

Attach the inlet hoses to the HOT and COLD

faucets. Being sure the hose marked “HOT” is

attached to the HOT water faucet. Tighten by

hand until snug and then 2/3 of a turn with pli-

ers. Do not overtighten.

Attach the inlet hoses to the HOT and COLD

connections on the back of the washer. HOT

and COLD connections are identified by

H & C stamped on the bracket, HOT on top,

COLD on bottom. Be sure the hose marked

“HOT” is attached to the HOT connection.

Tighten by hand until snug and then 2/3 of

a turn with pliers. Do not overtighten.

STEP 8

Turn on faucets and check for leaks at the

faucets and at the machine connections. If

leak occurs, check for cross-threaded or loose

connections.

1 2 3 4 5 6

Comments to this Manuals

No comments