Maytag MHP1000SQ User Manual download pdf (Page 5)

The pedestal arrives with the feet tight against the bottom of the

unit. Using a 1/4" hex head ratchet or open-end wrench, lower

the feet approximately 1" away from the bottom of the pedestal.

Tip the washer/dryer back to its upright position. Remove

and discard any remaining packaging material.

COMPLETE THE INSTALLATION

Follow the installation instructions that came with your model

to nish installing or reinstalling your washer/dryer (i.e., hoses,

vents, etc.).

Place a level on top edges of washer/dryer, checking each side

and front. Rock machine back and forth to make sure all four

feet make solid contact with oor.

If not level, adjust pedestal feet up or down, repeating as

necessary.

Locate the 1/4" hex head screws on the top of each pedestal

foot. Reach inside the pedestal and use a 1/4" hex head ratchet

or open-end wrench to adjust the feet up or down as needed to

level the washer/dryer.

7. Stand the washer/dryer upright

9. Check levelness of washer/dryer

10. Adjust pedestal feet

Not Level

LEVEL

Not Level

Place level here

8. Move close to nal location

(25 mm)

6. Prepare pedestal feet

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Maytag MHP1000SQ User Manual Page 5