Maytag MHP1000SQ User Manual download pdf (Page 3)

INSTALLATION INSTRUCTIONS

BEFORE INSTALLING PEDESTAL

IMPORTANT: If your washer and dryer are already installed,

they must be uninstalled.

Uninstalling your washer

NOTE : If the washer is to be transported, call your local service

center. To prevent suspension and structural damage, your

machine must be properly set up for relocation by a certied

technician.

Turn off the hot and cold water faucets.1.

Unplug the power supply cord.2.

Slowly loosen the ll hoses at the faucets to relieve the water 3.

pressure. Use a sponge or towel to absorb the released water.

Remove the “HOT” and “COLD” ll hoses from the back of 4.

the washer. Drain the water from the hoses into a bucket.

Remove the drain hose from the standpipe or laundry tub 5.

and drain any water remaining in the hose into a bucket.

Pull the washer away from the wall so it can be tipped on its 6.

back.

Protect the oor with a large piece of cardboard cut from the 7.

pedestal carton. Lay the washer on its back (make sure that

the power supply cord is not under the washer) so that the

cardboard is under the entire lower back edge of the washer.

An additional small amount of water will drain out of the 8.

washer when it is tipped back. Go to “Installing the Pedestal”

section.

Uninstalling your electric dryer

Unplug the power supply cord.1.

Pull the dryer away from the wall enough to loosen the vent 2.

clamp. Loosen the clamp and gently remove the exhaust vent

from the dryer exhaust outlet.

Pull the dryer away from the wall so that it can be tipped on 3.

its back.

Protect the oor with a large piece of cardboard cut from the 4.

pedestal carton. Lay the dryer on its back (make sure that

the power supply cord is not under the dryer) so that the

cardboard is under the entire lower back edge of the dryer.

Go to “Installing the Pedestal” section.

Uninstalling your gas dryer

1. Unplug the power supply cord.

2. Turn off the gas supply.

3. Pull the dryer away from the wall enough to loosen the vent

clamp. Loosen the clamp and gently remove the exhaust vent

from the dryer exhaust outlet.

4. Disconnect the exible gas supply line from the dryer. Put a

piece of tape over the open ends of the gas line connection

ttings.

5. Pull the dryer away from the wall so that it can be tipped on

its back.

6. Protect the oor with a large piece of cardboard cut from

the pedestal carton. Lay the dryer on its back (make sure

that the power supply cord is not under the dryer) so that

the cardboard is under the entire lower back edge of the

dryer. Go to “Installing the Pedestal” section.

WARNING

Excessive Weight Hazard

Use two or more people to move and uninstall washer.

Failure to do so can result in back or other injury.

WARNING

Excessive Weight Hazard

Use two or more people to move and uninstall dryer.

Failure to do so can result in back or other injury.

WARNING

Excessive Weight Hazard

Use two or more people to move and uninstall dryer.

Failure to do so can result in back or other injury.

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Maytag MHP1000SQ User Manual Page 3

Comments to this Manuals

Related products and manuals for Washers Maytag MHP1000SQ