Maytag Stacked Washer/Dryer Operations Instructions download pdf (Page 3)

CustomerSe,_Jice A4__

2a(]EdwardsStreet.SE

Cleveland,Tennessee37311

Tel:423-472-3333

Fax:423-478-6718

Untape and open washer lid. Remove installation accessory package, fill hoses and drain

hose and close lid. Leave tub block in place until installation is complete. Be sure to remove

tub block after installation is complete and before use. !

Using the carton corner posts stacked in pairs, lay the washer on the posts on the left side.

Remove the crate base wires from the carton base. Use pliers or screwdriver to pry wires

from wood. (Do not kick the shipping base off of the washer).

Run the washer rear legs all the way up into the rear corner brackets and lock in place by

tightening lock nuts. Leave the front legs loose for leveling in a following step.

Install vinyl feet on the washer legs.

With the washer laying down, check belt tension and motor track freedom. Lay a piece of

the shipping cardboard along the bottom edge of the cabinet and stand the washer back up.

(The cardboard protects the lower edge at the cabinet and the floor when standing the washer

back up).

NOTE: With the rear washer legs adjusted up, cabinet corner brackets in the rear can touch

and damage floor if caution is not used when moving washer

The dryer and stand are installed first. Necessary electrical, gas, (if gas stacked

washer/dryer) and vent connections are made as dryer and stand are put in position and lev-

eled. Let's first look at what facilities are needed.

1 2 3 4 5 6 7 8 ... 25 26

No comments

Maytag Stacked Washer/Dryer Operations Instructions Page 3