Maytag Stacked Washer/Dryer Operations Instructions download pdf (Page 20)

Cus 0meS0r,

240 EdwardsStreet,SE

Cleveland,Tennessee37311

Tel:423-472-3333

Fax:423-478-6710

INSTALLATION

INSTALL DRYER UNIT AND STAND

The dryer and stand are installed first. With the connections prepared for exhausting, electric

power and gas (if gas stacked washer/dryer, see Gas Connection), the dryer and stand are

moved to the location.

NOTE: When moving the dryer and stand on an appliance hand truck, it is recommended

that the dryer and stand be trucked upside down. Protective padding should be used to avoid

damage to the cabinet finish.

Install the vinyl feet on the dryer stand legs. Note the rear legs are "washer" legs and use

the larger feet.

Install electric power cord (electric stacked washer/dryer). See Electrical Requirements sec-

tion.

The vent connection is lined up from underneath the dryer as the dryer and stand are moved

back into position when a straight-out-the-back vent is used. When venting down, up, or to

the side, an elbow or fiat duct section is placed on to the dryer exhaust before the dryer is

slid into position.

Level the dryer and stand and lock leveling legs using leg lock nuts.

Connect gas line for gas units and check for leaks. Use a liquid soap solution or leak detec-

tor. DO NOT use a match or open flame !

With dryer "andstand in position, exhaust vent connected, unit leveled and gas line connected

(if gas unit), power cord set installed (if electric unit), plug power cord into electric outlet.

INSTALL WASHER UNIT

Install washer glide bars on rear of washer cabinet. The glide bars are in the installation

package found in the washer tub. Install with rounded edge down. The glide bars will

extend beyond the edge of the cabinet on each side when properly installed.

[] MA_/I'AG Admiral _J m JENN1.A]I:I _"i_lgi¢: C,_le[

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Maytag Stacked Washer/Dryer Operations Instructions Page 20