Maytag MSD2355HE Owner's Manual download pdf (Page 87)

No indicator lights

are lit on dispenser

control

Ice or water are

not dispensed

when pads are

pressed

Ice maker is not

producing enough

ice or ice is

malformed

Ice maker is not

producing ice

Water filter

indicator light is

red

Verify that freezer door is closed. Power is removed

from the control when freezer door is opened.

Plug in refrigerator.

Replace any blown fuses.

Check circuit breakers for any tripped circuits.

Call local power company listing to report outage.

See Sabbath Mode page 19.

Verify that freezer door is closed. Power is removed

from the control when freezer door is opened.

See Dispenser Lock page 19.

At initial use, there is an approximate one- to two-

minute delay in dispensing while the internal water

tank is filling.

Wait 24 hours for ice production to begin or for ice

maker to restock after emptied.

Change water filter (see page 20).

Wait 24 hours for ice production to begin or for ice

maker to restock after emptied.

Low water pressure can cause valve to leak.

Water pressure must be between 35 to 100 pounds

per square inch to function properly. A minimum

pressure of 35 pounds per square inch is

recommended for refrigerators with water filters.

Change water filter (see page 20).

Confirm ice maker arm is down. See Automatic Ice

Maker page 17.

See Connecting the Water Supply pages 4 and 5.

Turn off water supply and remove kinks.

If kinks cannot be removed, replace tubing.

Water pressure must be between 35 to 100 pounds

per square inch to function properly.

A minimum pressure of 35 pounds per square inch is

recommended for refrigerators with water filters.

See Temperature Controls pages 10, 11 and 12 to

adjust controls. Freezer must be between 0° to 2° F

(-18° to -17° C) to produce ice.

See Ice Storage Bin page 16.

See Connecting the Water Supply pages 4 and 5.

Self-piercing and

⁄16" saddle valves cause low water

pressure and may clog the line over time. The

manufacturer is not responsible for property damage

due to improper installation or water connection.

If filter is not available, replace with bypass filter.

See Water Filter page 20.

See Filter Status Indicator Light page 19.

Freezer door is not closed.

Refrigerator is not plugged in.

Fuse is blown, or circuit breaker needs to

be reset.

Power outage has occurred.

Refrigerator is in Sabbath Mode (select

models).

Freezer door is not closed.

Controls are in lock mode (select models).

Water tank is filling.

Ice maker has just been installed or a

large amount of ice has been used.

Water filter is clogged or needs to be

changed.

Ice maker has just been installed or a

large amount of ice has been used.

Water pressure is too low.

Water filter is clogged or needs to be

changed.

Ice maker arm is up.

Household water supply is not reaching

water valve.

Copper tubing has kinks.

Water pressure is too low.

Check freezer temperature.

Ice bin is not installed properly.

Improper water valve was installed.

Water filter needs to be replaced.

Filter indicator sensor needs to be reset.

PROBLEM

POSSIBLE CAUSES WHAT TO DO

Ice and Water

Troubleshooting

continued…

1 2 ... 82 83 84 85 86 87 88

Comments to this Manuals

No comments

Maytag MSD2355HE Owner's Manual Page 87

Comments to this Manuals