Maytag MSD2355HE Owner's Manual download pdf (Page 61)

7

Installation

Full-Length Aluminum Handles

To Install:

1. Release top door trim by removing

Phillips screws from top of fresh food

door and retain screws for later use.

2. Align notches on back of handle with

retaining clips on doors. Insert clips

into notches and slide handle

down until it contacts bottom

trim.

3. Replace top door trim and

Phillips screws.

4. Repeat instructions 1-3 to install

other handle.

To avoid possible injury and damage to property,

tape decorative panels (select models) securely into

place before removing door handles.

WARNING

To Remove:

1. Release top door trim by removing

Phillips screws from top of fresh food

door and retain screws for later use.

2. Grasp handle firmly with both hands.

Slide handle upward

approximately

3

⁄4" to release.

3. Repeat instructions 1-2 to

remove other handle.

To Reinstall:

1. Repeat in reverse order.

Door Clip

Wide-by-Side™ Handles

To Install:

1. Align fresh food handle with trim

retainer and door clip.

2. Make sure the tabs of the handle clip

are below the tabs of the door clip.

3. Rotate the handle so that the handle is

flat against the door (see page 6).

4. The tab on the lower part of the handle

will align with the hole in the handle

cap.

5. Slide handle upward until it clicks.

6. Snap top of handle into trim retainer

clip.

7. Repeat for freezer handle.

To Remove:

1. Protect the area above the handle

trim with tape. Insert the tip of a flat blade

screwdriver between the handle trim and door

panel. Carefully pry the trim away from the door

panel.

2. Pull trim free from the trim retainer.

3. Insert door removal card (or

1

⁄32

" thick plastic card))

between the handle and door panel (approximately

1

1

⁄2").

4. Grasp the handle firmly and pull downward to

remove.

5. Repeat for freezer handle.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

Comments to this Manuals

No comments