Maytag MSD2355HE Owner's Manual download pdf (Page 32)

Disassembly Procedures

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test

procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.

Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Auger Motor Assembly (some models)

1. Remove auger ice bucket and fast freeze shelf.

2. Remove light bulbs

3. Remove two hex head screws, one from each side of

cover.

4. Lift and slide assembly toward the front, disconnect

wiring harness and remove assembly.

Auger Motor (some models)

1. Remove auger drive hex nut.

2. Remove three hex nuts holding auger motor to

assembly.

3. Disconnect wires from auger motor capacitor.

4. Reverse procedure to reassemble.

Auger Motor Capacitor (some models)

1. Remove auger ice bucket and fast freeze shelf.

2. Remove auger motor assembly. (see auger motor

assembly removal.

3. Disconnect leads from capacitor, remove hex screw

and remove capacitor.

4. Reverse procedure to reassemble.

Evaporator Fan Motor Assembly

1. Remove all freezer shelving.

2. Remove lower evaporator cover hex head screws.

3. Remove evaporator cover.

4. Disconnect evaporator fan wiring and ground from

motor.

5. Raise top freezer cover about two inches.

6. Grasp and pull complete evaporator motor assembly

toward you.

7. Remove assembly from freezer.

FAN BLAD

HROUD

SSEMBLY

VAPORATOR

MOTOR

EVAPORATOR FAN

CLIP

Evaporator Fan Motor and Fan Blade

1. Remove evaporator fan motor assembly (see

evaporator fan motor assembly removal).

2. Remove evaporator fan blade by pulling blade off

evaporator fan shaft.

3. Remove fan motor by squeezing motor retainer clips

together to release retainer.

4. Remove retainer and slide motor out.

5. Reverse procedure to reassemble. Evaporator fan

blade should be pushed down on on shaft until it is

seated.

Freezer Thermistor

1. Remove Icemaker bucket.

2. Remove Icemaker by removing hex head screws and

unplugging icemaker harness.

3. Remove upper freezer shelves to access freezer back.

4. Remove freezer back hex head screws.

5. Rotate back to expose freezer thermistor.

6. Cut wire at thermistor and remove thermistor.

Evaporator Removal

NOTE: Reclaim refrigerant per instructions in “Service

Procedures” before attempting evaporator

removal. To avoid system contamination, do not

leave system open for more than 10 minutes.

1. Remove all freezer shelving.

2. Remove lower evaporator cover hex head screws.

3. Remove evaporator cover.

4. Remove defrost thermostat and defrost heater from

coil ( see disassembly instructions for both).

5. Release evaporator coil from clips by pulling coil off of

clips.

6. Unsweat evaporator coil after completing reclaiming

procedures found in Service Procedures section of this

manual.

7. Reverse procedure to reassemble.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Comments to this Manuals

No comments

Maytag MSD2355HE Owner's Manual Page 32

Comments to this Manuals