Maytag MSD2355HE Owner's Manual download pdf (Page 36)

Ice ‘N Water Systems

Troubleshooting of 5 button electronic Ice ‘N Water dispenser

Dispenser Operation

Select WATER, CRUSHED or CUBED mode by pushing the button on the dispenser panel. A green indicator light

above the button indicates the current selection. Selection mode cannot be changed from CRUSHED to CUBED or

from CUBED to CRUSHED while ice dispenser is in operation.

Dispenser Light

Light activates at full power when dispensing ice or water. A sensor activates light at half-power when light level

around refrigerator is low. Activate or deactivate sensor by pushing AUTO LIGHT button located on control façade.

Green light above AUTO LIGHT button indicates sensor is active.

Dispenser Lock

Prevents operation of water and ice dispensers. To activate or deactivate lock, press and hold DISPENSER LOCK

button for 3 seconds. Green light above button indicates dispenser lock.

Automatic Lock Out

Shuts down both ice and water mechanisms of dispenser when either mechanism has run continuously for 5

minutes. To return power to dispenser, press and hold DISPENSER LOCK for 3 seconds. Auger motor shuts off

automatically after 3 minutes of continuous operation. After about 3 minutes in shut-off state, auger motor

resets automatically.

Filter Status Light

This feature reminds users to replace water filter after 1 year have passed or after 500 gallons of water are

filtered, whichever happens first.

NOTE: Filter status light turns red after 1 year have passed or after 500 gallons of water are dispensed, even if

bypass is installed and unit is used without filter cartridge.

Green light indicates filter in good condition. Red light indicates filter replacement needed.

The filter monitor works by keeping track of time:

• Six months is approximately 16 million seconds.

• The refrigerator’s water system requires about 53,000 seconds to pass 500 gallons of water.

• Each second that water is dispensed counts as 1.20 ounces of water.

• An additional 3.20 ounces of water is counted every 30 minutes. This attempts to account for ice usage.

Filter Status Light Reset

Once filter light turns red, it remains red until reset. To reset filter indicator, press both DISPENSER LOCK and WATER

pushbuttons simultaneously and hold for 4 seconds. Make sure green light flashes 3 times when indicator

resets.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

No comments

Maytag MSD2355HE Owner's Manual Page 36