Maytag WINSLOW PI40 User Manual download pdf (Page 31)

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

4. Installing the standoffs, parts G. There are 3 standoffs on the top

panel D (see Figure 57). Insert them by taking the lip of the standoff

and sliding them into the slots then push down. Using a sheet metal

screw provided screw them into the hole provided. There is also one

standoff on each the right, left and the back panel. Showing standoff

on left panel C in Figure 58.

2. Assembling the perimeter - Figure 55

: Using the sheet metal screws

provided, attach the left side panel B and the right side panel C to the

back panel A. There are 3 holes at each corner to connect the panels,

at this point only install the lower two screws at each corner.

3. Install the top panel D. Place panel D on top of panels A, B, and C as

shown in Figure 56. There are 3 holes across the top of the panel

on each side. Insert the screws only on the right and left side. The 3

remaining holes in panel D will be used in step ﬁve.

Figure 55

Figure 56

Figure 57

Figure 58

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

No comments

Maytag WINSLOW PI40 User Manual Page 31