Maytag WINSLOW PI40 User Manual download pdf (Page 13)

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Trim stud

Door Handle

Holes for trim studs

Trim Nuts

#10 washers

Trim Pieces

Top of Trim

Figure 15

Figure 16

Figure 17

Figure 18

4. Place one washer on each stud. Using a 3/8” nut driver, snug up the

nuts on each piece of trim. Do not ﬁnish tightening the nuts yet. See

Figure 19

5. There should be approximately a 7/8” (22 mm) gap between the top

edge of the upper trim and the top edge of the door and a 1-1/2” (38

mm) gap between the bottom trim to the bottom of the door. Visually

inspect the alignment of the trim and adjust if necessary. See Figure

20.

6. Finish tightening nuts.

CAUTION - DO NOT OVER-TIGHTEN NUTS,

DIMPLING OF THE TRIM WILL OCCUR!!!

Figure 20

Figure 19

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Maytag WINSLOW PI40 User Manual Page 13