1DC68-02033B-03AUTOMATIC DRYER INSTALLATION INSTRUCTIONSMISE EN SERVICE SÉCHEUSE AUTOMATIQUEINSTRUCCIONES DE INSTALACIÓN DE LA SECADORAAUTOMÁTICAThe i
103-WIRE SYSTEM CONNECTIONS1. Loosen or remove center terminal block screw.2. Connect neutral wire (white or center wire) of power supply cord to the
11FINAL INSTALLATION CHECK LIST Dryer is plugged into electrical outlet and is properly grounded. Exhaust duct work is hooked up and joints taped.
12ADDITIONAL INSTRUCTIONS FOR EXPORT MODELS(Not U.S. Mexico, or Canada) Contact the distributor that sold the appliance or: Maytag International,1475
131. Disconnect power supply to unit.2. Remove 2 screws on door hinge.3. Lift the door and remove fromdryer.4. Remove 2 screws on oppositeside of door
2Note:The height of the dryer from top to floor is 38" with the leveling leg screwed all the way in. The customer canunscrew the leg out an addit
3IMPORTANT TO INSTALLERPlease Read The Following Instructions Carefully Before Starting To Install The Dryer. These InstructionsShould Be Retained For
4EXHAUSTINGExhausting the dryer to the outside will prevent large amounts of lint and moisture from being blowninto the room.In the United States:• Al
5• Exhaust systems longer than recommended can extend drying times, affect machine operationand may collect lint. • The exhaust duct should end wit
GAS REQUIREMENTSUse only Natural or LP (liquid propane) gases.THE INSTALLATION MUST CONFORM WITH LOCAL CODES, OR IN THE ABSENCE OF LOCALCODES, WITH TH
7GROUNDINGThis dryer must be grounded. In the event of malfunction or breakdown, the ground will reduce therisk of electrical shock by providing a pa
8• If a power cord is used, the cord should be plugged into a 30-ampere receptacle.• The power cord is NOT provided with U.S. electric model dryers.IM
9INSTALLATIONParts and literature are packaged inside of dryer drum.To Install...1. Move dryer to an appropriate location for installation. Consider i
Comments to this Manuals