Maytag MGR5729 User's Guide download pdf (Page 9)

Surface Cooking ooooooooooooooooooooooooo°oooooooooo

S JPfaoe Oontp Js Setting the Controls

If flame should go out during a cooking operation, turn

the burner off. If a strong gas odor is detected, open a

window and wait five minutes before relighting the

burner.

• Be sure all surface controls are set in the OFF position

prior to supplying gas to the range.

Pilotless Ignition

Pilotless ignition eliminates the need fk_ra constant standing

pilot light. Each surface burner has a spark ignitor. When

cleaning around the surface burner use care. If cleaning cloth

should catch the ignitor, it could damage it preventing igni-

tion.

If the surface burner does not light, check if ignitor is broken,

soiled or wet. If clogged, clean the small port beneath the

ignitor using straight pin.

BURNER HEAD

ON SELECT MODELS

PORT BELOW IGNITOR

Surface Control Knobs

Use to turll on the surface burners. An //_%_

infinite choice of heat settings is available

from LOW to HIGH. At the HIGH

setting a detent or notch may be felt. The

knobs can be set on or between any of the

settings.

Graphics next to the knob identify which burner the knob

controls. For example, the graphic below shows the right rear

burner location. 'lib •

,11111,,11111,

1. Place a pan on tile burner grate.

0 The burner flame nmy lift off or appear separated

from the port if a pan is not placed on the grate.

2. Push ill and turll tile knob counterclockwise to tile

LIGHT setting.

A clicking (spark) sound will be heard and the

burner will light. (All four ignitors will spark when

any surface burner knob is turned to the LIGHT

position.)

3. After tile burner lights, turn tile knob to tile desired

flame size.

0 Tile ignitor will continue to spark until tile knob is

turned past the LIGHT position.

Suggested Heat Settings

Tile size and type of cookware will affect tile flame

setting. For infornmtion on cookware and other factors

affectin_ flame settings,refer t( Cooking Made Simple .

Setting_

HIGH

LOW

Uses

Use tu bring liquid to a boil,

or reach pressure ill a O

pressure cooker. Always

reduce setting to a lower

heat when liquids begin to " ' .......

boil or foods begin to cook.

An interinediale flame size is used to continue

cooking. Food will not cook any faster when a

higher flame setting is used than needed to

maintain a gentle boil. Water boils at the same

temperature whether boiling gently or vigorously.

Use t° simmer f°°ds' keep _mY"N_ __

foods warm and melt /_

chocolate or butter,

Operating During a Power Failure

1. Hold a liehtedo match to the desired surface burner head.

2. Push ill and turn the control knob slowly to LIGHT.

3. Adjust the flame to the desired level.

CAUTION: When lighting the SurfaC_ burners;

b e sure a!l of the controls are in the OFF position; Stri ke I

the matc h first an d ho!d it in POsition bef°re turning the I

knob to LIGHT. I

iii!i:i:i:i:i:i:i:i:i:i:i:i:i:i:i:iii

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Maytag MGR5729 User's Guide Page 9

Comments to this Manuals

Related products and manuals for Cookers Maytag MGR5729