Maytag M1200 Use and Care Manual download pdf (Page 9)

3.4.2

URNING ON YOUR IRON

1. Rest unplugged iron on its heel.

2. Plug the iron into a grounded electrical outlet.

You will hear a beep when plugged in, but the iron is NOT heating up yet.

3. To heat up, press the Temperature Control Button 1 time to • for (Nylon/Synthetics).

This is the lowest setting.

4. A single light will flash for about 30 seconds.

5. Light stops flashing and beeps.

6. Iron away.

For Silk/Wool setting ••; at step 3, press Temperature Control Setting Twice.

For Cotton setting •••; at step 3, press Temperature Control Setting Three times.

For Linen setting MAX; at step 3, press Temperature Control Setting 4 times.

3.5 Turning Off Your Iron

1. Press down on the Temperature Control Setting for

about 3 seconds. See Figure H.

2. Lights will turn off while a beep sounds at the same time.

3. The iron has been turned off.

Figure H

4. Unplug the iron.

5. Stand iron upright on its heel to cool down.

Note: The iron will remain hot after turning off. Allow ample time to cool down

prior to handling and storing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

No comments

Maytag M1200 Use and Care Manual Page 9