Maytag M1200 Use and Care Manual download pdf (Page 6)

3. OPERATING YOUR IRON

3.1 Before First Use

 Remove any protective packaging, films, or stickers from the soleplate and the iron.

 Read all “Safety Guidelines.” See section 1.

 Fill Removable Water Tank as instructed in “Filling Removable Water Tank.” See page

section 3.3.

 Plug the iron into a grounded electrical outlet.

You will hear a beep when plugged in, but the iron is NOT heating up yet.

 To heat up, press the Temperature Control Setting 4 times to MAX. This is the highest

setting.

 The MAX light will flash for about 60 seconds.

 When MAX light stops flashing and beeps, the iron is ready.

 It is normal for a small amount of smoke and a light odor to be produced the first time

the iron is used; this won’t last long.

 Particles may emit from the iron the first time it is used. They are not harmful and

should dissipate once used.

 Move the Steam Control/Self-Clean to maximum. This is the continuous steam setting.

 Iron for the first time on an old towel or a heavy material until the Removable Water

Tank is empty and no more steam is produced. This will help to eliminate any particles

in the iron.

3.2 Control Features

3.2.1

TEAM

ONTROL

 Slide the steam switch towards the front of the iron to increase the amount of the

steam.

 Slide the switch towards the back of the iron to decrease or turn the steam off.

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

No comments

Maytag M1200 Use and Care Manual Page 6