Maytag MDG78PN User Manual download pdf (Page 3)

113255-1 Maytag 3

General User Information

Non-Coin Models “OPL Dry Mode” ____

Cold Start (Initial/First Use)

This appliance has 20 preset cycles, which are ready for

use. To start the unit, use the UP ( ) and DOWN ( )

ARROW keys to scroll through the preset cycles, until the

desired cycle is highlighted, then press the START/ENTER

(

!) key. A detailed description of the preset cycles is on a

chart on page 8. While a cycle is running you can press

the STOP (X) button once to pause the cycle or twice to

clear it completely.

Hot Keys

Clear Current Drying Cycle

While machine is idle displaying “CYCLE PAUSED

RESTART CYCLE” OR “PRESS PAUSE TO CLEAR”, press

the STOP (X) key and the cycle will be terminated.

Clear Fault Message

While machine is displaying any fault message press and

hold the STOP (X) key for 3-seconds.

General User Information

Coin/Debit Models “Coin Dry Mode”__

Cold Start (Initial/First Use)

Appliance is programmed at the factory as follows:

Dryer

10 minute dry time/quarter (coin 1)

$.25 dry price

Warm Start (After Power Failure)

A few seconds after power is restored, if a cycle was in

progress at the time of the power failure, the display will

prompt “Select Cycle to Restart”. This is to indicate the

need for a setting to be pressed to restart dryer.

Pricing

After the door is opened following the completion of a cycle,

the display indicates the cycle price (unless set for free

operation). As coins or debit inputs arrive, the display will

change to lead the user through the initiation of a cycle.

There are 2 types of pricing:

Accumulative Time

In this Vending Mode each coin inserted has a specific value

in time, which is determined by the “Time for Amount to

Start”.

Accumulative Coin

In this Vending Mode additional time can only be achieved

when the “Time for Top Off” has been inserted.

Note

A maximum of 99 minutes may be purchased; no

additional credit is given when 99 minutes is in the display.

“Free Dry Mode”

When the Dry Mode is set to FREE, only one cycle time is

initially vended. Pressing and holding the HIGH or LOW

key for 3-seconds will allow the time to be adjusted. Pressing

HIGH will increase the time in 1 minute units and pressing

LOW will decrease the time in 1 minute units. Once the

desired time is chosen, pressing MED will save the new

time.

Hot Keys

Clear Credit

While machine is idle displaying “SELECT A CYCLE” press

and hold PAUSE, while holding PAUSE press HI, HI, HI,

LO, LO, MED within 3-seconds and the control will display

“CLEAR CREDIT?” While still holding PAUSE press any

key to clear credit. Releasing PAUSE then pressing any

key will not clear credit.

Display Fault Message

While machine is displaying “OUT OF ORDER” press the

LO key.

Display Credit Remaining

While machine is displaying “OUT OF ORDER” press the

HI key.

Clear “Out of Order”

While machine is displaying “OUT OF ORDER” press and

hold the PAUSE key for 3-seconds.

Introduction to Programming ________

The keypad, along with the digital display, is used to setup

the dryer control.

Entering and Exiting Service Mode

Entering:

Non-Coin (OPL) Models

To enter the Program Mode you must hold the STOP (X)

key and the UP ARROW ( ) key down.

Coin/Debit Models

Use security key to activate programming mode.

Exiting:

The ENTER (

!) key must be depressed to save any changes

that have been made.

Non-Coin (OPL) Models

Exit Service Mode by pressing the STOP (X) key.

Coin/Debit Models

Return security key back to its normal position.

1 2 3 4 ... 12

Comments to this Manuals

No comments

Maytag MDG78PN User Manual Page 3

Comments to this Manuals

Related products and manuals for Electric laundry dryers Maytag MDG78PN