Maytag MDB7749SAM0 Specifications download pdf (Page 19)

Be sure rubber washer is properly seated in fitting. Slide the

3/4"fitting up to the valve and hand tighten to avoid cross-

threading. Hand tighten until the coupling is tight.

Using pliers, check the tightness of the coupling. An additional

1/4to 1/2turn may be required to seal the rubber gasket.

NOTE: Do not overtighten. Damage to the coupling can result.

Place paper towel under 90° elbow fitting. Turn on water supply

and check for leaks. If leak occurs, repeat previous step.

If needed, see website for animated representation of this step.

Visit www.maytag.com/watersupply under FAQ tab.

Connect to Drain

Place towel under drain hose to catch any water in drain hose.

Place the small drain hose clamp onto the small end of the drain

hose. Push the new drain hose into the black drain hose

connector up to the drain hose stop.

Using pliers, squeeze open the small drain hose clamp and slide

onto connector between stops.

Drain hose

Black drain hose

connector

After hose is connected, remove towel.

If needed, see website for animated representation of this step.

Visit www.maytag.com/drain under FAQ tab.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

No comments

Maytag MDB7749SAM0 Specifications Page 19