Maytag MHW4300DC User Manual download pdf (Page 15)

Operate your washer only when you are home. If moving, or

not using your washer for a period of time, follow these steps:

1. Unplug or disconnect power to washer.

2. Turn off water supply to washer to avoid ﬂooding due

to water pressure surges.

3. Clean dispensers. See “Cleaning the Dispensers.”

WINTER STORAGE CARE

IMPORTANT: To avoid damage, install and store washer

where it will not freeze. Because some water may stay in

hoses, freezing can damage washer. If storing or moving

during freezing weather, winterize your washer.

To winterize washer:

1. Shut off both water faucets, disconnect and drain water

inlet hoses.

2. Put 1 qt. (1 L) of R.V.-type antifreeze in washer drum

and run washer on NORMAL cycle for about 2 minutes

to mix antifreeze and remaining water.

3. Unplug washer or disconnect power.

NON-USE AND VACATION CARE

TRANSPORTING YOUR WASHER

1. Shut off both water faucets. Disconnect and drain water

inlet hoses.

2. If washer will be moved during freezing weather, follow

WINTER STORAGE CARE directions before moving.

3. Disconnect drain hose from drain system and from back

of washer.

4. Unplug power cord.

5. Place inlet hoses and drain hose inside washer drum.

6. Bundle power cord with a rubber band or cable tie to keep

it from hanging onto the ground.

IMPORTANT: Call for service to install new transport bolts.

Do not reuse transport bolts. Washer must be transported

in the upright position. To avoid structural damage to your

washer, it must be properly set up for relocation by a certiﬁed

technician.

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

Refer to Installation Instructions to locate, level, and

connect washer.

Before using again, run washer through the following

recommended procedure:

To use washer again:

Flush water pipes and hoses. Reconnect water inlet hoses.

Turn on both water faucets.

Plug in washer or reconnect power.

Run washer through NORMAL cycle to clean washer and

remove antifreeze, if used. Use only HE detergent. Use half

the manufacturer’s recommended amount for a medium-size

load.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Comments to this Manuals

No comments

Maytag MHW4300DC User Manual Page 15

Comments to this Manuals

Related products and manuals for Washers Maytag MHW4300DC