Maytag MAH5500B User Manual download pdf (Page 11)

EFORE You Call

For problem laundry solutions (i.e. fabric damage,

residue, tangling) and special laundry care procedures,

see the enclosed Laundering Tips booklet.

Check these points if your Maytag Neptune® washer... '

Load is Too Wet at

End of Cycle

• Use Max Extract option.

• Try using a high efficiency detergent to reduce sudsing.

• Load is too small.Very small loads (one or two items) may not spin out completely.

Leaks Water

• Make sure door is firmly dosed.

• Make sure hose connections are tight.

• Make sure end of drain hose is correctly inserted and secured to drain facility.

• Avoid overloading.

• Use high efficiency detergent to prevent over-sudsing.

Won’t Spin

or Drain

• Check fuse or reset circuit breaker.

• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.

• Close the door and push the start/pause pad. For your safety, washer wilt not tumble or

spin unless the door is closed.

• After pressing the start/pause pad, it will take a few moments before the clothes washer

begins to spin. The door must lock before spin can be achieved,

• See “Tub is Completely Full of Suds” below.

Stops

• Plug cord into live electrical outlet,

• Check fuse or reset circuit breaker.

• Close door and push the start/pause pad to start the clothes washer. For your safety,

washer will not tumble or spin unless door is closed.

• This may be a pause or soak period in the cycle. Wait briefly and it may start.

• Check screens on inlet hoses at the faucets for obstructions. Clean screens periodically.

Tub is Completely

Full of Suds

• Run the clothes washer through another complete cycle using cold water.

• Reduce detergent amount for that specific load size, soil level and water hardness.

• Use high efficiency or low sudsing detergent specially formulated for front load washers.

Fills with the

Wrong

Temperature

Water

• Turn both faucets on fully.

• Make sure temperature selection is correct.

• Make sure hoses are connected to correct faucets and inlet connections. Flush water line

before filling washer.

• Check the water heater. It should be set to deliver a minimum I20°F (49°C) hot water at

the tap. Also check water heater capacity and recovery rate.

• Disconnect hoses and clean screens. Hose filter screens may be plugged.

• When warm rinse is selected, only the final rinse will be warm. The first two

rinses will be cold.

• As the washer is filling, the water temperature may change as the automatic temperature

control feature checks incoming water temperature. This is normal.

CONT.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Maytag MAH5500B User Manual Page 11

Comments to this Manuals

Related products and manuals for Washers Maytag MAH5500B