Maytag MET3800XW Installation Guide download pdf (Page 24)

In Canada

4. Plug into a grounded 4-prong outlet

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra

part, go back through the steps to see which step was

skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials. Keep the plastic

foam for use if the washer/dryer should be transported.

Check the washer/dryer’s nal location. Be sure the vent is

not crushed or kinked.

Check that the washer/dryer is level and front leveling feet

are tight. See “Level Washer/Dryer.”

In the U.S.A.:

For power supply cord installation, plug into a grounded

outlet. For direct wire installation, turn on power.

In Canada:

Plug into a grounded 4-prong outlet. Turn on power.

Check that the water faucets are on.

Check for leaks around faucets and inlet hoses.

Remove the blue protective lm on the console and any tape

remaining on the washer/dryer.

Read the Washer/Dryer Use and Care Guide.

Wipe the dryer drum interior thoroughly with a damp cloth

to remove any dust.

To test the washer, measure 1/2 the normal recommended

amount of detergent and pour it into the washer. Close the

lid. Select HEAVY and pull out the Cycle Control knob. Allow

the washer to complete one whole cycle.

To test the dryer, set the dryer on a full heat cycle (not an air

cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

• Controls are set in a running or “On” position.

• PUSH TO START button has been rmly pushed.

• Washer/dryer is plugged into a grounded outlet.

• Electrical supply is connected.

• Household fuses are intact and tight, or circuit breakers

have not tripped.

• Dryer door is closed.

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat.

If you do not feel heat, turn off the dryer and check the

following:

• There may be 2 household fuses or circuit breakers for the

dryer. Check that both fuses are intact and tight, or that

both circuit breakers have not tripped. If there is still no

heat, contact a qualied technician.

NOTE: You may notice an odor when dryer is rst heated. This

odor is common when the heating element is rst used. The odor

will go away.

LEVEL WASHER/DRYER

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Comments to this Manuals

No comments

Maytag MET3800XW Installation Guide Page 24

Comments to this Manuals

Related products and manuals for Washer dryers Maytag MET3800XW