Maytag JENN-AIR Owner's Manual download pdf (Page 58)

Temperature Control Guide

Refrigerator too warm

Refrigerator too cold

Freezer too warm

Freezer too cold

Turn refrigerator OFF

Set the refrigerator control

to next higher number by

pre

ssing the pad.

Set the refrigerator control

to next lower number by

pressing the pad.

Set the freezer control to

next higher number by

pressing the pad.

Set the freezer control to

next lower number by

pressing the pad.

Press the refrigerator or

freezer pad until a dash

(–) appears in the display.

Initial Control Settings

After plugging the refrigerator in, set the controls.

• Pressing the or pads adjusts the controls to

the desired setting.

• The temperature control range for both

compartments is 1 through 7 (coldest).

• Initially set the refrigerator control on 4.

• Initially set the freezer control on 4.

• Let the refrigerator run at least 8 to 12 hours before

adding food.

Warm Cabinet Surfaces

At times, the front of the refrigerator cabinet may be

warm to the touch. This is a normal occurrence that

helps prevent moisture from condensing on the

cabinet. This condition will be more noticeable when

you first start the refrigerator, during hot weather and

after excessive or lengthy door openings.

Temperature Controls

Touch Temperature Controls

The controls are located at the top front of the

refrigerator compartment.

Control

Adjusting the Controls

• 24 hours after adding food, you may decide that one

or both compartments should be colder or warmer. If

so, adjust the control(s) as indicated in the

Temperature Control Guide table below. See page 19

for instructions on checking compar

tment

temperature.

• Except when starting the refrigerator, do not change

either control more than one number at a time.

• Allow 24 hours for temperatures to stabilize.

• Changing either control will have some effect on the

temperature of the other compartment.

Energy Saver Switch (select models)

• Off - The refrigerator uses more energy when this

switch is off, because a heater located in the hinged

seal section of the door is running. This heater helps

prevent condensation formation on the exterior of the

hinged seal. Turn the energy saver switch OFF when

the environment is warm and more humid or if

moisture is noticed on the door exterior.

• On - T

his setting saves energy by not using the

heater. Turn the energy saver switch ON when the

environment is less humid.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 76 77

Comments to this Manuals

No comments

Maytag JENN-AIR Owner's Manual Page 58

Comments to this Manuals

Related products and manuals for Vacuum cleaners Maytag JENN-AIR