Maytag JENN-AIR Owner's Manual download pdf (Page 32)

Disassembly Procedures

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test

procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.

Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Light Bulb Sockets

1. After following procedure on removing light bulb

assembly.

2. Disconnect wires to sockets.

3. Squeeze tab on back side of socket to release it from

assembly.

4. Reverse procedure to reassemble.

Defrost Timer (some models)

1. After following procedure on removing light bulb

assembly.

2. Remove hex head screws holding timer to assembly.

3. Disconnect plug from timer.

4. Reverse procedure to reassemble.

DEFROST TIME

Mechanical Control Model

PC Control Board (some models)

1. Remove light shield by sliding shield to rear to release

cover.

2. Depress with a screw driver through two slots in the

front of the light housing release tabs to release

Control Board housing.

3. Control Board housing will drop down exposing

Control Board.

4. Unplug two wire harnesses plugged into the Control

Board.

5. Release tabs holding Control Board to housing.

CONTROL BOARD

RELEASE TABS

LIGHT COVER

Mid Level Electronic Model

Light Switch

1. After following procedure on removing light bulb

assembly.

2. Disconnect wires from light switch.

3. Squeeze tab to release light switch from light

assembly.

4. Reverse procedure to reassemble.

Temp- Assure

Damper Control (some models)

1. Remove light shield.

2. Remove damper control cover and foam insert by

pulling straight on sides of rear cover and tilt forward

1/2” to 1”. This will release the cover from the tabs

holding it in place.

3. Release tension on damper control belt by

squeezing tabs on bottom of belt tensioner to

release tensioner from it’s holding tabs.

4. Slip belt off of damper control cog.

5. Damper can be removed by pushing in tabs on left

and right side of damper control to release damper

from rear wall.

6. Reverse procedure to reassemble.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 76 77

Comments to this Manuals

No comments

Maytag JENN-AIR Owner's Manual Page 32

Comments to this Manuals

Related products and manuals for Vacuum cleaners Maytag JENN-AIR