Maytag W10438304A User Manual download pdf (Page 4)

Powder and Gels

• The amount of detergent to use depends on:

How much soil remains on the items - Heavily soiled loads

require more detergent.

The hardness of the water - If you use too little in hard water,

dishes won't be clean. If you use too much in soft water,

glassware will etch.

Soft to Medium Water (0-6 grains per U.S. gallon)

[typical water softener water and some city water]

Medium to Hard Water (7-12 grains per U.S. gallon)

[well water and some city water]

• Depending on your water hardness, fill the Main Wash section

of the dispenser as shown. Fill the Pre-Wash section to the

level shown, if needed.

NOTE: Fill amounts shown

are for standard powdered

detergent. Follow instructions

on the package when using

other dishwasher detergent.

Add Rinse Aid

HardWater

SoftWater

HardWater

SoftWater

MainWash Prs-Wash

• Your dishwasher is designed to use rinse aid for good drying

performance. Without rinse aid your dishes and dishwasher

interior will have excessive moisture. The heated dry option will

not perform as well without rinse aid.

• Rinse aid keeps water from forming droplets that can

dry as spots or streaks. It also improves drying by

allowing water to drain off of the dishes after the final

rinse.

Rinse aid helps to reduce excess moisture on the

dish racks and interior of your dishwasher.

Check the rinse aid indicator. Add rinse aid when indicator

drops to "Refill" level.

To add rinse aid, turn the

dispenser cap to "Open"

and lift off. Pour rinse aid

into the opening until the

indicator level is at "Full."

Replace the dispenser cap

and turn to "Lock." Make

sure cap is fully locked.

NOTE: For most water

conditions, the factory setting of

2 will give good results. If you

have hard water or notice rings or

spots, try a higher setting. Turn

the arrow adjuster inside the

dispenser by either using your

fingers or inserting a flat-blade

screwdriver into the center of the

arrow and turning.

USERINSEAIDFOR

BETTERDRYINGLock i

Open_ Add

1/4turn to lock

Full

Add

Select a Cycle (cycles vary by model)

NOTE: Heavier cycles and

options affect cycle length.

Some cycles and options will

take up to 31/2hours to

complete.

Heavy - Use for heavily soiled,

hard-to-clean items.

Normal - Use for normal food

1-hr rinse

heavy normal lisht wash only

cycles

soil. The energy usage label is based on this cycle.

Light - Uses less energy for lightly soiled loads.

1-Hr Wash - Use for lightly soiled items. For fast results, 1-Hr Wash

will clean the dishes using slightly more water and energy.

Rinse Only - (no options apply to this cycle) Do not use detergent.

This is only a rinse that keeps food from drying on your dishes and

reduces odor buildup in your dishwasher until you are ready to

wash a full load.

Select Options (options vary by model)

You can customize your cycles by

pressing the options desired. Repeatedly

press the button until the desired option

is selected.

Hi-Temp - (use only with Heavy and

Normal wash cycles) heats the water

during the wash portions of the cycle to

enhance cleaning.

high sani heated4-hr

temp rinse dry delay

o!ol

select options

Sani Rinse - (all cycles except Light and Rinse Only) To sanitize

your dishes and glassware in accordance with NSF/ANSI Standard

184 for Residential Dishwashers. Raises the water temperature in

the final rinse to approximately 155°F (68°C). Certified residential

dishwashers are not intended for license food establishments.

Heated Dry - (all cycles except Rinse Only) use for best drying

results. Turn off by pressing Heated Dry so that the light goes off.

4-Hr Delay - (any cycle) offers the choice to start the dishwasher

automatically at a later time. Select a wash cycle and options.

Press 4-Hr Delay. Press START/RESUME. Close the door firmly.

STEP4

Start or Resume a Cycle

• Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water.

• Push door firmly closed. The door latches ,u

automatically. Select the wash cycle and options

desired and press START/RESUME OR press START/

LLJ

RESUME to repeat the same cycle and options as in

the previous wash cycle, start

resume

• You can add an item anytime before the main wash

starts. Open the door slowly and add the item. Close the door

firmly. Press the START/RESUME button, the cycle resumes

automatically at the point of interruption.

You may cancel a cycle anytime by pressing

CANCEL/DRAI N.

cancel

drain

1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments

Maytag W10438304A User Manual Page 4

Comments to this Manuals

Related products and manuals for Dishwashers Maytag W10438304A