Maytag CANYON C310 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Brick insTallaTion
canyon™ c310 Brick insTallaTion
CAUTION: Wear gloves during brick installation in
case of sharp edges behind the stove.
Note: Installation of baffle bricks and ceramic blanket is
much easier when you can still access the flue outlet, as in
before installing the insert. Be sure the insulating blanket
is placed flat on the bricks so as not to block the flue and
that it does not hang out over the front of the baffle. Use
a ruler or a piece of kindling to reach back over the blanket
to be sure it is flat on top of the baffle bricks all the way
back.
Install bricks #1-30 in the numbered sequence. (Note:
Bricks 22-25 lean up against the lower air channeland butt
against bricks 17-21 on the bottom of the stove) Next install
bricks 35-40 on top of the stainlesssteel secondary tubes
in the upper part of the firebox. These bricks fit up against
bricks 26-30 on the backwall and should rest on the rear
two stainless steel tube spports running front to rear down
the cemter of thestove. Included in your stove are two
13”x17”x1” thick ceramic fiber blankets. Install a ceramic
fiberblanket on top of each of these sets of two sets of three
bricks making sure the blanket is pushed fully tothe rear.
Next install bricks 41-46 under the ceramic fiber blanket
and on top of the front two stainlesssteel secondary tubes.
(Caution: Make sure that the front of the ceramic fiber
blanket does notproject beyond bricks 41-46.)
WARNING: IF THE BRICKS AR NOT INSTALLED EXACTLY
AS SHOWN THEY COULD FALL OUT OF PLACE DURING
REFUELING OR BURNING OF THE STOVE CAUSING SERI-
OUS INJURY.
canyon™ c310 Brick Sizes
(see Figures on this page)
A = 3-7/8 x 8-3/4”
B = 6-1/2 x 4-1/2”
C = 3-1/2 x 9”
D = 1-1/2 x 4-1/2”
E = 3-7/8 x 9”
F = 4-1/2 x 9”
G = 3 x 9
H = 3-1/2 x 4-1/2
J = 4-1/2 x 7
K = 3 x 7
M - 4-1/2 x 4-1/2
Insulating Blanket Size is 1/2” x 11” x 20” and fits on
top of the baffle brick.
Baffle Brick Layout
Stainless Steel
Tube Support
Baffle Brick
Insulating Blanket
Secondary Burn Tubes
Rear Brick Go
Behind Baffle
Brick
Side View
M Brick
M
2-1/2”
1/2”
4-1/2”
* These bricks go up against
the stoves back wall.
Firebox Brick Layout
Baffle Blanket Placement
Figure 1
Figure 2
Figure 3
46
K
45
J
44
J
35
F
36
F
37
G
40
G
39
F
38
F
41
J
42
J
43
K
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments