Maytag MD-31 Installation Manual download pdf (Page 9)

Control Panel - clean with a soft, damp

cloth. Do not use abrasivesubstances.

Tumbler- removeany stains such as cray-

on, ink pen or fabric dye (from new items

such as towels or jeans) with an all-purpose

cleaner.Then tumble old towels or rags to

remove any excess stain or cleaning sub-

stance. Once these steps are done, stains

maystill bevisible, but should not transferto

subsequent loads.

Cabinet - wipe offany marks with soap and

water.

Dryer Exhaust System - should be

inspected and cleaned once a year to main-

tain optimum performance. The outside

exhaust hood should be cleaned more fre-

quently to ensure proper operation. (Refer

to the Installation Instructionsfor more infor-

mation.)

Instructionsfor replacing the bulb:

1) Unplug or disconnect the dryer from the

electrical power supply.

2) Open the door and use a Phillips screw-

driver to removethe screw attaching the

lens to the tumblerfront.

3) Remove lens cover by pulling cover

toward center of tumbler.

4) Rotate bulb counter-clockwise to

remove from socket.

s)

s)

7)

Replacethe bulbwith a 120volt, 10 watt

maximum candelabra base light bulb.

Turn the light bulbclockwise into socket.

Replace lens cover by hooking plastic

tabs into tumbler front below the light

housing.

s)

Reinstall the screw into the lens cover

screw hole.

9) Reconnectdryer to power supply.

Directionsfor reversingthe dryer door:

1) Remove the hinge hole covers and

screws.

2) While supporting the door, remove 2

screws in the hinges that secure the

hinges to the cabinet.

3) Remove door by lifting slightly at the

hinges and pulling the hinge tabs out of

the hinge slots.

4)

S)

Movethe following parts to the opposite

side of the door: 2 hinges and 4 hinge

screws, 4 door screws, door strike and

screw, innerdoor cover plate and screw.

Attach the door to the opposite side of

the cabinet using the 2 counter sunk

hinge screws. (See below).

Door Catch

Screwthe lower hingescrew infirst.Thiswill

help to align the door and hinges.

6) Replace the hinge hole covers to the

opposite side.

Counter Sunk Screw

i

t

i _I i i

i i

._.....Door

Screws

Door

Strike

Door

_Screws

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments