Maytag MRT711BZDH Use and Care Manual download pdf (Page 9)

Install Refrigerator Door

1. Replace the parts for the bottom hinge as shown. Tighten

screws.

NOTE: Provide additional support for the doors while the

hinges are being moved. Do not depend on the door magnets

to hold the doors in place while you are working.

2. Lower the bottom of the refrigerator door onto the bottom

hinge pin.

3. Measure the distance from the bottom of the refrigerator door

to the floor. The distance should be approximately 3¹⁄₂"

(88 mm).

NOTE: If necessary, loosen the bottom hinge without

removing the screws, adjust the door to the correct height and

fully tighten the screws.

4. Assemble the parts for the center hinge as previously shown

and tighten all screws. See center hinge graphic.

Install Freezer Door

1. Place washer on the upper hinge pin of the center hinge.

2. Place the freezer door on the upper hinge pin of the center

hinge.

3. Insert the top hinge pin into the drilled hole in the top of the

freezer door. Do not tighten the screws completely.

4. Align the doors so that the bottom of the freezer door aligns

evenly with the top of the refrigerator door. Tighten all screws.

NOTE: The distance between the doors should be

approximately ⁵⁄₈" (16 mm).

Final Steps

1. Remove the cover from the base grille. Move cover to the

opposite side.

2. Push the base grille toward the cabinet until it is flush.

3. Plug in the refrigerator or reconnect the power.

4. Reset the controls. See “Using the Controls.”

5. Return all removable door parts to doors and food to

refrigerator.

A. Bottom hinge

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Maytag MRT711BZDH Use and Care Manual Page 9