Maytag POF1HD140AVFA Operations Instructions Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
APPENDIX C OIL PRIMARY CONTROL DETAILED SEQUENCE OF OPERATION
Power is applied to unit. The oil primary control completes a self-diagnostic procedure. If no light or flame is present,
and unit passes its self-diagnostic procedure, the control enters into the idle mode.
Thermostat calls for heat:
A) Safety check is made for flame (4 second delay).
1) If flame is not present, the oil primary control will apply power to the burner motor and igniter.
2) If flame is present, the control remains in the idle state.
B) Unit enters a pre-purge period of 15 seconds.
C) After 10 seconds, control checks for flame presence.
1) If flame is not present, the oil primary control enters the trial for ignition state.
2) When flame is present, the control enters lock out mode.
D) The Oil Primary Control monitors the burner flame.
1) When flame is present, the control enters ignition carryover state. (Continues to spark for 10 sec.).
a) Provides continuous spark after flame is sensed to assure that burner remains lit.
b) Turns on LED diagnostic light.
c) Starts carryover timer.
(i) Flame and call for heat are monitored.
If flame is lost and lockout timer has not expired, the control will return to trial for ignition state.
If flame is lost and lockout timer has expired, the control will enter the recycle state.
Recycle timer starts.
Burner motor and igniter and solenoid valve are turned off.
LED diagnostic light flashes slowly.
E) Carryover timer expires.
1) Enters run state.
a) Igniter turns off.
Combustion continues until thermostat is satisfied, or the oil primary control detects a loss of flame and enters into
Recycle Mode.
F) Thermostat is satisfied - call for heat is terminated:
a) Oil primary control shuts off burner motor and solenoid valve.
(i) If the control utilizes a blower motor off delay, after 30 seconds, flame presence is checked.
If flame is not present, the control LED diagnostic light is off and returns to idle state.
If flame is presence is detected, the control enters lock out mode.
19
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments