Maytag SkyBox MBV1976AA User Manual download pdf (Page 6)

STE

P 3 – Install Shelves

TEP 2 – Level the Stand

Stand Assembly

Carefully unpack the stand parts (see below) from the

packaging.

Tools Needed:

• #2 phillips head screw driver • Level

• Adjustable Wrench

Parts Quantity

A End Frame.......................................................................................................2

B Long Support Rail.......................................................................................4

C Rear Leveling Legs (attached to end frames)..............................2

D Shelves..............................................................................................................2

E Pan-Head Screws.....................................................................................24

F Left Side Panel (with hinge holes).....................................................1

G Right Side Panel (with no hinge holes)...........................................1

H Back Panel ......................................................................................................1

I Door....................................................................................................................1

J Hinges (attached to the door)..............................................................2

K Front Foot.........................................................................................................2

L M5 x 16 Hex-Phillips Head Cap Screw -

⁄

” (16mm) long....6

M Front Foot Leveling Head........................................................................2

N Flat Head Screws.........................................................................................6

FF M5 x 20 Hex-Phillips Head Cap Screw -

⁄

” (20mm) long....2

P 1 – Assemble Frame of Stand

x 3

K/M

Lx 3

Assembly

• Attach the two front feet (K) to the bottom of the

two corner posts using three M5 x 16,

⁄8 ” (16 mm)

long, Hex-Phillips head cap screws (L) for each foot.

NOTE: The threaded bolt on the front foot must

extend outward away from the frame (see figure).

• Attach the front foot leveling head (M) to the

threaded bolt on each front foot (K).

• Carefully place the partially assembled stand on the

floor where it will be displayed. Adjust the front foot

leveling heads (M) down so that the front foot roller

is just off the floor. Using a level and an adjustable

wrench, adjust the two rear leveling legs (C) so the

unit sits squarely on the floor.

• Place bottom shelf (D) on top of lower support rails.

Align screw holes and install four pan-head screws

(E).

• Repeat procedure for center shelf (D) which mounts

on the four tabs welded to the end frame.

• Connect one long support rail (B) to one of the end

frames (A) by inserting the tabs on the support rail

into the slots of the end frame and pressing

downward. The support rails will temporarily lock into

place when pressed downward.

• Connect the other end of support rail to a second

end frame (A) by inserting the tabs on the support

rail into the slots of the end frame and pressing

downward.

• Repeat procedure for remaining 3 rails, creating a

basic frame for the cabinet. DO NOT INSTALL ANY

SCREWS (E) DURING THIS STEP!

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Comments to this Manuals

No comments

Maytag SkyBox MBV1976AA User Manual Page 6

Comments to this Manuals

Related products and manuals for Water dispensers Maytag SkyBox MBV1976AA