Maytag MVWX600XW Use and Care Guide download pdf (Page 5)

PREWASH

Use this option to add an extra agitation and soak time

to the beginning of any cycle to break up tough stains.

WASH

You will hear the motor and washplate moving the load.

Unlike traditional washers, the load is not covered with water.

Low-water cleaning means concentrated cleaning. Rather

than diluting detergent as done in an agitator-style washer,

this washer delivers the detergent directly to the soils. The

motor sounds may change at different stages in the cycle.

The wash time is determined by the selected soil level.

RINSE

You will hear sounds similar to the wash cycle as the washer

rinses and moves the load. You may hear the motor turning

on briey (short hum) to move the basket while lling. Fabric

softener will be added if the Fabric Softener option was

selected. Some cycles use spray rinsing.

SPIN

The washer spins the load at increasing speeds for proper

water removal, based on the selected cycle and spin speed.

DONE

Once the cycle is complete, this light will come on. Remove

the load promptly for best results.

CYCLE STATUS LIGHTS INDICATOR

The Cycle Status Lights shows the progress of a cycle.

At each stage of the process, you may notice sounds

or pauses that are different from traditional washers.

SENSING

When the Start/Pause/Unlock button is pressed,

the washer will rst perform a self-test on the lid

lock mechanism. You will hear a click, the basket

will make a slight turn, and the lid will unlock briey

before locking again.

Once the lid has locked the second time, the washer

will use short, slow spins to estimate the load size.

These sensing spins may take 2 to 3 minutes before

water is added to the load and you may hear the hum

of these spins. If the sensing light is on, the washer

is working properly. You will hear the motor turn the

basket in short pulses to thoroughly wet the load. The

washer will then move the load briey, pause to allow

water to soak in to the load, and resume adding water.

This process may repeat until the correct amount of

water has been added for the load. You may also hear

water owing through the dispenser, adding detergent

to the load.

NOTE: Avoid opening the lid during sensing. The

sensing process will start over when the washer

is restarted. The sensing light may also come

on during the Prewash and Wash portions of the

cycle. This is normal.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments

Maytag MVWX600XW Use and Care Guide Page 5

Comments to this Manuals

Related products and manuals for Washing machines Maytag MVWX600XW